Graco 312492B User Manual

Repair
Drum Roller Kit
For transfering drums on and off a supply unit.
Model 255627
Read all warnings and instructions in 312371 man­ual. Save these instructions.
See page 4 for model information and approvals.
312492B
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
ti10951a

Maintenance

Maintenance
Read all warnings and instructions in 312371 man­ual.
Caution
The maximum weight capacity of the drum roller kit is 6,500 lbs. (2948.35 kg).
Assemble
1. Lay two side frames (2) on the ground. See parts illustration on page 3.
2. Install two cross frames (3), roller (1), and roller frame stop (4) on top of the two side frames (2).
3. Tigten screws (5) on the roller frame stop (4).
Install
1. Remove the drum from the supply unit and put the ram in down position.
2. Relieve pressure.
platen
lift rod
FIG. 1
strapping
ti10925a
Operation
1. Follow instructions Starting and Adjusting Ram in manual 312371.
2. Position full drum of material with bottom edge of drum on roller using drum dolly, fork lift, etc.
3. Roll drum into position on ram base.
3. Disconnect air hoses.
4. Turn OFF power.
5. Put the ram director valve in the neutral position.
6. Wrap strapping outside of the platen lift rods and lift the supply unit with a secure hoist.
7. Postion the roller kit at desired location. See Parts illustration on page 3 for bolt hole location.
8. Slowly lower the supply unit on the drum roller kit. Line up the holes of the drum roller kit and the sup­ply unit base.
9. Install 1/2 in. (13 mm) anchors (not supplied) through the ram base and drum roller kit to secure the supply unit to the ground.
2 312492B
Loading...
+ 2 hidden pages