Graco 2L00 User Manual

Replacement Parts

• Warranty Information (USA)

To purchase parts or accessories or for warranty information in the United States, please contact us at the

following:

www.gracobaby.com

1-800-345-4109

2L00

Product Registration

(USA)

To register your Graco product from

within the U.S.A. visit us online at

www.gracobaby.com/productregistration.

We currently do not accept product

registrations from those living outside the

United States of America.

Product Features

Parent’s Unit (PD141347) Model 2L00 - 1 unit

Power LED

Nursery Unit (PD141361) Model 2L00

Power

Power/Volume

Channel Selector

DC Adapter Jack

Channel Selector

Simple Sounds

Clip

DC Adapter Jack

AC Adapter Model 2L00 - Qty. 2

Failure to follow these warnings and the assembly instructions could result in serious injury or death.

This device is designed only to monitor the sounds of your child. It will not alert you to your child’s silent activities. When using the monitor, you must still provide the

supervision necessary for the continued safety of your child. This product is not designed or intended for use as a medical monitor. Always be sure that both the transmitter and receiver are working properly and are within range of each other.

• STRANGULATION HAZARD. Keep the adapter cords out of the reach of children. Do not use with extension cords.

• DO NOT place the Nursery Unit or its cord within your child’s reach. Do not put the Nursery Unit inside a crib or play yard.

• Use ONLY with 110-120 volt AC electrical outlets.

• Protect the AC adapter cords. Place them so they are not walked on or pinched by furniture or other items.

• Allow for proper ventilation when units are in use. Do not cover the Nursery Unit or Parent Units with any object such as a blanket. Do not place it in a drawer or in any location which would muffle the sound or interfere with the normal flow of air.

• DO NOT immerse any part of the Nursery Unit or Parent Units in water. Clean only with a dry cloth.

• DO NOT place unit near water and moisture. Do not use the Nursery Unit outdoors. Do not use the Nursery Unit near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub, swimming pool, wet basement, etc.

• Keep Nursery Unit away from heat sources, such as fireplaces, radiators, stoves, and TVs or other appliances. Heat can damage the case or electrical parts.

• DO NOT use the Nursery Unit if:

• The adapter cords or plugs have been damaged.

• The unit has been exposed to liquids.

• Unit has been dropped or is damaged.

• DO NOT OPEN THE NURSERY UNIT, PARENT UNITS, OR ADAPTERS. No user-serviceable parts inside. Risk of electrical shock, fire or death.

• The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm (7.9”) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Statement:

WARNING Modifications not authorized by the manufacturer may void users

authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• Look for the FCC ID on the bottom of the Nursery Unit and inside the Battery

compartment on the Parent Unit.

Simple Sounds

2L00

Graco Children’s Products 3 Glenlake Pkwy Atlanta, GA 30328

Battery Installation

Parent Unit

• Remove the battery door cover on the

Parent Unit with a key or flat blade screw driver.

• Place 3-AAA (1.5V-LR03) batteries into

the battery compartment. Note the proper orientation of the batteries.

• Do not mix old and new batteries.

• Do not mix alkaline, standard

(carbon zinc), or rechargeable (ni-cadmium, etc) batteries.

• Place the battery door back on the unit.

• Please remove a dead battery promptly.

Batteries should be disposed of

properly by recycling.

A dead battery left in the unit may leak, damaging your unit.

• Do not attempt to recharge a

non-rechargeable battery.

• A rechargeable battery CANNOT be recharged by plugging the AC adapter into the

Parent Unit.

• Remove the batteries from the unit if it is no longer being used or will be stored for an

extended period of time.

Using AC Adapters

• The Parent Unit uses 3-AAA (1.5V-LR03) batteries or standard 120 volt AC household

current. The Nursery Unit uses standard 120 volt AC household current.

• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side

of the Parent Unit and the back of the Nursery Unit. Then plug adapter into a standard wall outlet.

• Use ONLY the Graco adapters included with the unit. Do not use these adapters with

other equipment under any circumstances.

• If units do not work, check that AC adapters are plugged into working outlets.

Selecting Channels

• In case you are experiencing some interference, the

channel on the Nursery Unit can be changed by sliding the “ch” button on the side of the unit to either channel A or B ("X" or "Y").

• The channel on the Parent Unit can be changed by

sliding the “ch” button on the side of the unit to either channel A or B ("X" or "Y").

NOTE: Both units must be on the same channel.

Low Battery Indication

Parent Unit

• If operated too long on a low battery, you may also experience a poor signal and the Power LED on the front of the parent unit may change from green to red.

• You may either turn off the unit, plug in the A/C adapter.

Out of Range Indication

•If the Parent Unit begins to lose the signal from the Nursery Unit you may hear static or other noise. Immediately move the Parent Unit closer to the Nursery Unit to regain connection.

***Note: It is not uncommon for the Parent Unit to occasionally

lose and regain connection with the Nursery Unit in environments that have a significant amount of obstructions.

Setting Up the Baby Monitor

1. For optimum operation, it is best to use new batteries in the Parent Unit.

2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery Unit. Plug it into a working 120 volt AC outlet.

3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission.

4. Set both the Nursery Unit and Parent Unit to the same channel, “A” or “B” (“X” or “Y”).

5. Turn on the Nursery Unit using the On/Off switch on the side. The green power light should come on.

6. Place the Parent Unit within five (5) feet (1.5 meters) of the Nursery Unit and turn on the Parent Unit using the On/Off switch on the side of the unit. The green power light should come on.

7. Your monitor is now ready for use.

+ 8 hidden pages