Page 1
Instructions - Parts
Light Tower Kit
3A1906A
Diagnostic indicator for use with a Graco Control Architecture (GCA) controlled system.
Kit 24K337
3
Important Safety Instructions
Read all warnings and instructions in your system
manuals. Save all instructions.
3a
3b
Installation
Install the light tower somewhere it will be visible to the
operator during system use. Light tower must be located
within 10 ft (3 m) of the Advanced Display
Module (ADM) unless an extension cable is used. See
page 2 for available cables.
Mounting
Surface
(For Reference Only)
EN
1. Use lag screws (6) and gasket (2) to install
bracket (1) in desired light tower location.
2. Guide the hard-wired light tower cable through the
opening in the bracket (1) then use screws (3a),
washers (3b), and nuts (3c) to secure light tower to
bracket.
3. Connect supplied accessory cable (5) to hard-wired
light tower cable. Connect other end to open connector on ADM. Route cable so that it is protected
from damage.
3c
ADM
(For Reference Only)
ti18612a
512
6
Page 2
Parts Light Tower Signals
Mounting
Surface
(For Reference Only)
3
3a
3b
3c
ADM
(For Reference Only)
Signal Description
Green on only System is powered up and there are no
error conditions present.
Yellow on A low priority error (advisory) exists.
Red Flashing A medium priority error (deviation)
exists.
Red on The system is shut down due to a high
priority error (alarm) condition.
NOTE: See system manual for specific errors associated with the light tower signals.
Optional Extension
Cables
Part Length
123658 28 ft (8.5 m)
ti18612a
512
6
Ref. Part Description Qty.
1 16K322 BRACKET 1
2 125642 GASKET 1
3 15X472 LIGHT TOWER 1
3a --- SCREW 3
3b --- WASHER 3
3c --- NUT, hex 3
5 124415 CABLE, 5-pin, male/female, 3.0 m 1
6 100464 SCREW, lag 4
All written and visual data contained in this document reflects the latest product information available at the time of publication.
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2012, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 3A1906
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
www.graco.com
Loading...