Page 1
ASSEMBLY INSTRUCTIONS
Description
: ACCENT TABLE W/SHELVES
Printed in Vietnam
Page 2
Printed in Vietnam
BEFORE ASSEMBLY
PART LIST
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call us toll free.
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
- Remove all wrapping material, including staples & packing straps before you start to assemble.
- DO NOT tighten all screws and bolts until completely assembled.
- Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A
C
Top
Shelf
1
1
B
D
Side frame
(L-R)
Bottom
panel
2
1
- 2 -
Page 3
HARDWARE LIST
NO Description
Qty Sketch
NO
Description
Qty Sketch
STEP 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
1
3
5
Long bolt
(M6x35mm)
Lock washer
(6.5x11mm)
Allen key
(4X80mm)
8
8
1
Flat washer
2
(6.5x16mm)
Shelf support
4
6
(M3.5X15mm)
bracket
Screw
8
4
4
Attach side frame (B) to the top (A) with bolt (1), washer (2) and (3) as shown below. Tighten with
Allen key (5).
- 3 -
Printed in Vietnam
Page 4
Printed in Vietnam
STEP 2
Attach bottom panel (D) to the side frame (B) with bolt (1), washer (2) and (3) as shown below.
Tighten with Allen key (5).
- 4 -
Page 5
Printed in Vietnam
STEP 3
Attach brackets (4) to the unit as shown below.
STEP 4
Attach the Adjustable Shelf (C) to the unit with screws (6) as shown below. Tighten with a screwdriver.
- 5 -
Loading...