Gracie Oaks GRKS5094 Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS

j

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box. Carefully unpack your new fixture
and lay out all the parts on a clear area. Take care not to lose any
small parts necessary for installation.

2. Attach the mounting plate to the Junction Box with the two junction
box screws as shown. The side of the cross bar marked "GND" must
face out. The junction box is not included.

3. By measuring, determine correct cord length needed for proper
hanging height, then lock it securely with small screw(D). Press the
‘cable lock’ and adjustment steel cable to the proper length. Slide
safety lock to the proper position, lock it securely with the screws.
ADVICE: if you do not adjust hanging height later, you may properly
cut the cord and steel cable is too long parts.

4. While holding the canopy(A) towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape.
If your outlet has a ground wire (green or bare copper), connect the
fixture ground wire to it. Otherwise connect fixture’s ground wire
directly to the Mounting strap with the green screw provided. After
wires are connected, tuck them carefully inside the Junction Box.

5. Raise the canopy(A) onto the junction box, aligning screws on
mounting plate with mounting holes in canopy and lock it securely
with the ball nuts(B). Raise the bulb(C: GU10, included) inset the
lamp holder of canopy and turn it until tighten. Return the lamp
holder(E) to upright position, raise the candle sleeve(F) insert the
lamp holder.

6. Install the light bulbs(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE ! Please use plastic clips to secure the cord on the
steel cable suitable location.

Your installation is now complete. Return power to the

unction box and test the fixture.

FIG.1

Cable

Lock

FIG.2

Need assistance with parts or assembly? Please call customer service

ALL RIGHTS RESERVED.

FIXTURE
WIRES
Black or
Smooth

Safety

Lock

JunctionBox

(Notincluded)

Mountingplate

Mountingscrew

BoxScrew

A

B

C

Plastic clips

E

G

FIXTURE

WIRES
White or

Ribbed

HOUSE
WIRES
Black(Hot)

Thank you for purchasing a product.

HOUSE
WIRES
White
(Neutral)

D

F

FIXTURE
WIRES
Bare
Copper
(Ground)

HOUSE

WIRES

Green or Bare

Copper(Ground)