Page 1
Caution : You must read this before you proceed
CAUTION : This Chair is NOT a TOY. Keep your child / children at bay in the process of assembly.
ROCKING CHAIR
For turning the chair and to prevent damage to the Table, 02 persons may be needed to execute this
action
1 of 7
Page 2
Label Picture Description QTY
A
1
Panel
Right Arm with Leg
Left Arm with Leg
B
1
Panel
C Backrest Panel 1
D Seat Panel 1
E Seat Cushion 1
F Back Cushion 1
No. Picture Description Qty
①
②
③
④
Long Screw M6x80mm 5
Long Bolts M6x95mm 3
Short Bolts M6x80mm 3
Sleeve Nut M6x15mm 5
⑤
⑥
Short Screw M6x35mm 5
Allen Key 2
2 of 7
Page 3
Before Beginning Assembly:
OVERVIEW
FRONT
Backrest
Panel (C)
Le� Leg
Panel (A)
Back Cushion (F)
Right Leg Panel (B)
Seat
Cushion(E)
Seat Panel (D)
FACING
This Chair has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Chair, the above picture is to help you
put the various parts into perspective. Please read through the instructions here
below to familiarise the parts and steps before assembly.
3 of 7
Page 4
Unpack and place all parts on a clean, non-marring surface.
2.1) Position Seat Panel (D) to Left Leg Panel (A)
Step 2
Step 1
A
B
2.1
2.2
Then, position Right Leg Panel (B) onto Seat Panel (D) as shown in picture
above
2.2) Secure Right Leg Panel (B) to Seat Panel (D) by using Screw (①), and
Allen Key ( ⑥), Then Using Screw(⑤
with Left Leg (A)
Do not fully tighten the Screws.
4 of 7
) and Allen Key(⑥) to secure Seat Panel (D)
Page 5
With assistance from your adult partners, turn the Chair into the other side.
Repeat the same process of step 2 to secure Left Leg Panel (A) with Seat Panel
Step 3
Step 4
Turn the Chair right side up.
Do not fully tighten the Screws.
(D) by using Screw( ①), and Allen Key (⑥), Then using Screw(⑤
Key(⑥) to secure Seat Panel(D) with Right Leg Panel (B)
Do not fully tighten the Screws.
) and Allen
Position Backrest Panel (C) to Leg Panels (A & B) as the picture above
Secure Leg Panels (A), (B) to Backrest Panel (C) by using Long Bolts (②)&
Sleeve Nuts (④) and Allen Key (⑥)
5 of 7
Page 6
Step 6
Step 5
Keep Chaiir
Position Backrest Panel (C) to Leg Panels (A & B) as the picture above
Do not fully tighten the Screws.
Inspect the Chair and make sure all parts are connected.
Secure Leg Panels (A), (B) to Backrest Panel (C) by using Short Bolts (③)&
Sleeve Nuts (④) and Allen Key (⑥)
Place Back Cushion (F) and Seat Cushion (E) onto the Chair
Tie the velcro straps of Back Cushion (F) to Backrest Panel (C) and Seat
Cushion (E) to Seat Panel (D).
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
6 of 7
Page 7
7 of 7
Loading...