GPX V997-01 User Manual

Clock Radio with Dual Alarm

User’s Guide for Model C303B v997-01

FCC Warnings

Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

FUNCTIONS AND CONTROLS

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Additional Warnings

• The apparatus shall not be exposed to dripping or splashing and that no objects lled with liquids, such as vases, shall be placed on apparatus.

• Do not place the unit on top of any soft, porous, or sensitive surfaces to avoid damaging the surface. Use a protective barrier between the unit and surface to protect the surface.

• This product is supplied with a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns and can lead to death.

• Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.

• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

• Batteries should be recycled or disposed of as per state and local guidelines.

Alarm 1 Buzzer/ Radio Indicator

Speaker

Volume/AL1/AL2

Press to adjust the volume.

Press and hold to begin

setting Alarm 1 or Alarm 2.

Radio/Power

Press to power on the Radio.

Press and hold to power o

the Radio. Press briey to switch between AM

and FM bands.

PM Indicator

Press to snooze the alarm after it sounds.

Press and hold to dim the brightness of the LED display.

LED Display Battery Status

TIME ZONE

AL1 AL2 HOUR MINUTE

SNOOZE

TUNINGVOLUME

CLOCK/ PRESETAM/FM DIMMER

Snooze/Dimmer

BuzzerBuzzer

RadioRadio

Alarm 2 Buzzer/ Radio Indicator

Tuning/Hour/Min

Press to tune the radio.

Press to adjust the minute

or hour when setting

the clock or alarm.

Preset/Clock

With the Radio on, press to

cycle through preset radio

stations. In o mode, press

and hold to adjust the clock.

DC Power Input

Power

Plug the AC/DC power adapter (included) into the DC Power Input on the unit, and a standard power outlet.

The unit can be used to charge mobie devices through a USB charging port in the rear, as seen on the right (USB cable not included).

USB CHARGER

OFF ON

DC IN

DST

Daylight

Savings On/O

FM ANT

Battery Backup

The battery backup is intended for short power outages only. The clock radio’s primary functions cannot run o of the battery backup alone. This unit uses a button cell battery that will last up to 1 year and maintains the time. Replace the battery if the low battery indicator lights up.

Bottom View

RELEASE

CR2032

CR2032 Button Cell

Battery (included)

SETTING THE CLOCK

Auto

When the unit is plugged in, the correct time will be displayed after a few seconds.

Manual

1. Press and hold the Clock button until the display

begins ashing.

2. Press the Hour and Minute buttons to adjust the time. The PM indicator will light when the hour is set in the PM.

3. Press the Clock button again set the day of the week. Press the Hour and Minute button to adjust the day from 1 to 7.

Example: 1 - Monday, 2 - Tuesday, etc.

4. Press the Clock button again to nish, or wait for the display to stop ashing.

Daylight Savings Time

On the rear of the unit is a switch marked DST ON/OFF. In the ON position, the time on the clock is moved ahead one hour. In the OFF position, it is moved back one hour.

Time Zone

When the unit is rst powered on, it is automatically set to Time Zone 2 - Eastern Standard Time. To change this setting, press the Time Zone button to select the desired time zone.

1 Atlantic Std Time UTC- 4 hrs

2 Eastern Std Time UTC- 5 hrs

3 Central Std Time UTC- 6 hrs

4 Mountain Std Time UTC- 7 hrs

5 Pacic Std Time UTC- 8 hrs

6 Alaska Std Time UTC- 9 hrs

7 Hawaii - Aleutian Std Time UTC- 10 hrs

RADIO

Radio Reception

Adjust the position of the FM Antenna to improve FM radio reception. An AM antenna is built into the clock radio. To improve AM radio reception, adjust the position of the clock radio.

Tuning the AM or FM Radio

1. Power on the radio by pressing the Power button. Press it again to switch between the AM and FM radio mode.

2. Press the Tunning ± buttons to nd the desired radio frequency.

3. Press the Volume ± buttons to adjust the volume of the radio.

Saving a Station as a Preset

1. With the radio on, tune to your desired frequency, press and

hold the Preset button until the screen ashes.

2. Press the Tunning ± buttons to choose the desired preset

station, 1 though 10.

3. Press the Preset/Clock button again to set the frequency to

that preset station.

4. The unit will store 10 FM and 10 AM radio station presets.

Once set, press the Preset/Clock button to cycle through your preset stations.

ALARM

Setting the Alarm

1. With the radio o, press and hold the AL1 or AL2 buttons to set the time for Alarm 1 or Alarm 2.

2. The screen will ash and display the time the alarm is set to go o. Press the Hour and Minute buttons to change the desired time. Note the PM indicator.

3. With the screen still ashing, press the AL1 or AL2 buttons again to set the weekly alarm schedule.

1-7 rings Mon-Sun | 1-5 rings Mon-Fri | 6-7 rings Sat-Sun

4. After the alarm is set and the screen has stopped ashing,

press the AL1 or AL2 buttons again to select how the alarm will sound with the Buzzer or the Radio. Press once more to deactivate the alarm entirely.

Snooze and Alarm Reset

After the alarm sounds, press the Snooze button to delay the alarm for an additional 9 minutes, or press the Power button to turn the alarm o until the set alarm time is reached again.

INTERNATIONAL SUPPORT

To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at: www.gpx.com Pour télécharger ce guide de l’utilisateur en anglais, espagnol ou français, ou pour obtenir des réponses à des questions fréquemment posées, consultez la rubrique d’assistance sur: www.gpx.com Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección de apoyo en: www.gpx.com

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215 | Email Support: prodinfo@dpiinc.com | Email Parts: partsinfo@dpiinc.com Copyright © 2013 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.