GPS-Buddy AT-S Quick Reference Manual

GPS-Buddy AT-S

Magnetic asset tracker

Quick reference guide

Congratulations on purchasing the GPS Buddy AT­S. In this manual you can read how you
can install and use the system fast and correctly.
Please read the manual before use
thoroughly.

Content of the box:

One magnetic asset tracker GPS Buddy AT-S in
splatter-proof casing
One quick reference guide

Our hard and software are improved constantly.
Due to this, the described functionality or speci­cations may differ at the moment of operation.

The supplier is not liable for typing or printing
errors in this document.

1/4

Introduction

Please note

• All equipment using Wi-Fi causes interfe­rence. This can have a distorting
effect on other equipment.

• The equipment is splatter-proof.

• GPS Buddy is not liable for any interruption
in the electronic circuit of the material or
machine the asset tracker is attached to.

• If you notice an interruption in the elec­tronic circuit, immediately disassemble
the asset tracker and call our helpdesk for
further instructions.

2/4

Operation of the system

LED-status description

Yellow lamp is on GPRS is operational

Yellow lamp blinks for 2 sec Mobile initialisation

Yellow lamp is off Mobile is in sleep mode

Blue lamp is on GPS is operational

Blue lamp is blinking look for GPS signal

Blue lamp is off GPS is in sleep mode

Red lamp is off System functions properly

Installing the GPS Buddy AT-S

Place the AT-S with the magnetic side in or on the
material/machine. We recommend installing the
AT-S in such a way that the reception of an GPS
signal is guaranteed.

Using the GPS Buddy AT-S

If a yellow and blue lamp are on on the AT-S,
the system is fully operational. The vehicle, the
material or the machines can be followed via the
planner app or the GPS Buddy Studio environment.
environment is followed. The location is establis­hed once a day (for three minutes).

3/4

Following the assets

• Create an asset in the GPS Buddy Studio environ­ment. Here you are asked to enter
the ID.

• After entering the IOT ID the asset tracker is
immediately operational.

Technical support

For questions about the operation, you can contact
the GPS Buddy helpdesk: [e-mail] or
by phone on [phone]. The opening hours are
Mondays to Fridays from 8 am to 6 pm.

You can download the detailed manual on: www.
gps-buddy.com/support/

4/4