GP Design P53, PP13, PR57 User Manual
Operation :
Full pressing (B)
Half press (B)
When light is on, press (C) to adjust brightness
Press (C) when flashlight Off
Press (C) when light is On
Light on (100%) ---> Light off
Momentary on
Light on (100%) ---> Light on (50%) ---> Light on (7%)
(the cycle repeats)
Instant strobe. If pressed more than 5 seconds, strobe
remains on. Press again to turn strobe off.
Press Mode switch for more than 3 seconds to activate
Strobe. Strobe remains on until mode switch is pressed
again. The flashlight resets to high output level.
Focus :
Single handed push pull head (D) Quick and easy focus
USER MANUAL
P53
Tail cap (A)
Battery : 3 x AAA - Alkaline or NiMH
Fitting batteries :
1. Make sure flashlight is off and unscrew the tail cap (A).
2. Remove old batteries and install new batteries in the correct polarity. Insert new batteries according to
the polarity indications (+) and (-) marked on the battery holder. Care to install all three batteries as
described as failure to do this may cause damage to the flashlight.
3. Screw the tail cap back into place. The torch is now ready for use.
Unscrew tail cap
anti-clockwise to
change batteries
Main switch (B)
Dual switch
Mode switch (C)
Focus lock /
unlock
Focusable
Head (D)
Focus lock :
Turn the Head (D) clockwise
Turn the Head (D) anti clockwise
Locks the focus
Unlocks the focus.
Features :
- Light modes : 3 – High / medium / low + strobe and momentary-on
- Focus / lock : Easy one handed instant focusing with focus lock
- Dual Switch for ease of use and operation
- Body durable aircraft grade aluminum with hard wearing anodized protective coating
- Polarity protection and PWM regulation for accurate light output
- Tail-stand and anti-roll
Specifications :
Lumens : 300lm / 150lm / 20lm
Candela : 4000cd
Beam distance : 120m
Runtime : 2h 30 min / 8h 30min / 28h
Waterproof : IPX4
Impact resistant : 1.5m
Battery : 3 x AAA – Alkaline or NiMH
LED : Cree XP-G2
Weighs : 115g without batteries
Dimensions : 122.8 x 35mm
Loading...