Govaplast Play Solid Board with 3 helms User Manual

User manual GP44

„Solid board with 3 helms“

Latest version can always be found at www.govaplay.com

According to EN1176, this product is not considered as being a play equipment. Therefore, a TÜV-certificate is not
required.

( version 2015-01)

35 x 120 cm, H 20 cm
+/- 9,5 kg

Mounting

This equipment is delivered fully assembled. It just needs to be
fixed onto a wall.

Material

Ÿ Solid board made of recycled plastic (PE), coloured
Ÿ Stainless steel fasteners
Ÿ PE helms, UV-resistant

Maintenance

Maintenance of the recycled plastic material is very limited.
Cleaning with a soapy water and a sponge or soft brush. Rinse with
water to remove all dirt and soap. As the water absorption of the
material is less than 0,29%, it will not get stained by oil, grease and
other products. Besides, mosses and algae will have difficult to
adhere to the material and are very easy to remove.
Cleaning with high-pressure (max. 100 bar) is possible but is not
recommended and mostly not needed. If anyway, then spray with a
fan-shaped jet at minimum 30 cm from the plastic surface.

Painting or staining is useless as the paint will not stick attach to
the material.

Govaerts Recycling NV | Kolmenstraat 1324 | B-3570 Alken | [e-mail] | www.govaplast.com

1

Installation

The Board GP44 is delivered fully assembled. It is to be fixed onto a
wall using the 8 included nail plugs. Position the board on the wall,
mark the 8 anchorage points (board is pre-drilled) and drill the holes in
the wall using a 8 mm stone drill bit. Then fix the nail plugs into the wall.

Important suggestion

To drill the holes in the ground, use a sharp drill and just put the plastic
plug into the hole. It is better to screw the nail into the plug than to
hammer. This way, you don't damage the head of the nail and unfixing
will be easy.

8 x

2

Govaerts Recycling NV | Kolmenstraat 1324 | B-3570 Alken | [e-mail] | www.govaplast.com