GotSat GS 1011 Owner's Manual
Terrestrial receiver
GS 1011
Owner´s manual
EN
► SAFETY INFORMATIONS
CAUTION
To reduce the risk of fi re and electric shock, do not remove
the cover (or back) of the unit. Refer servicing only to qualifi ed service personnel. The lightning fl ash with arrowhead
symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated „dangerous voltage“
within product‘s enclosure that may be of suffi cient magnitu-
de to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operation
and servicing instructions in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY
INSERT.
The apparatus shall not be exposed to dripping or splashing,
and that no objects fi lled with liquids, such as vases, shall
be place on the apparatus. Batteries shall not be exposed to
excessive heat such as sunshine,fi re or the like.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Where the mains plug or a appliance coupler is used as the
disconnect device, the disconnect device, the disconnect
device shall remain readily operable.
IMPORTANT SAFEGUARDS
In addition to the careful attention devoted to quality standards in the manufacture of your video product, safety is
a major factor in the design of every instrument. However,
safety is your responsibility, too. This sheet lists important
information that will help to assure your enjoyment and
proper use of the video product and accessory equipment.
Please read them carefully before operation and using your
video product.
INSTALLATION
1. Read and Follow Instructions- All the safety and operation
instructions should be read before the video product is operated. Follow all operating instructions.
2. Retain Instructions- The safety and operating instructions
should be retained for future reference.
3. Heed all Warnings-Comply with all warnings on the video
product and in the operating instructions.
4. Polarization- Some video products are equipped with a
polarized alternating -current line plug. This plug will fi t into
the power outlet, try reversing the plug. If the plug still fails to
fi t, contact your electrician to replace your obsolete outlet. To
prevent electric shock, do not use this polarized plug with an
extension cord, receptacle, or other outlet unless the blades
can be fully inserted without blade exposure. If you need an
extension cord, use a polarized cord.
5. Power Sources- This video product should be operated
only from the type of power source indicated on the marking
label. If you are not sure of the type of power supply to your
home, consult your video dealer or local power company. For
video products intended to operate from battery power, or
other sources, refer to the operating instructions.
6. Overloading- Do not overload wall outlets or extension
cords as this can result in a risk of fi re or electric shock.
Overloaded AC outlets, extension cords, frayed power cords,
damaged or cracked wire insulation, and broken plugs are
dangerous, They may result in a shock or fi re hazard. Peri-
odically examine the cord, and if its appearance indicated
damage or deteriorated insulation, have it replaced by your
service technician.
7. Power-Cord Protection- Power-supply cords should be
routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular
attention to cords at plugs, convenience receptacles, and the
point where they exit from the video product.
8. Ventilation- Slots and openings in the case are provided
for ventilation to ensure reliable operation of the video product and to protect it from overheating. These openings must
not the blocked or covered. The openings should never be
blocked by placing the video product on a bed, sofa, rug, or
heat register. This video product should not be placed in a
built-in installation such as a book case or rack, unless proper
ventilation is provided or the video product manufacturer‘s
instructions have been followed.
9. Attachments- Do not use attachments unless recommended by the video product manufacturer as they may cause
hazards.
10. Water and Moisture- do not use this video product near
water for example, near a bath tub, wash bowl, kitchen sink
or laundry tub, in a wet basement, or near a swimming pool
and the like. Caution: Maintain electrical safety. Powerline
operated equipment or accessories connected to this unit
should bear safety certifi cation mark on the accessory itself
and should not be modifi ed so as to defeat the safety fea-
tures. This will help avoid any and should not be modifi ed
so as to defeat the safety features. This will help avoid any
potential hazard from electrical shock or fi re. If in doubt, con-
tact qualifi ed service personnel.
11. Accessories- Do not place this video product on an
unstable cart, stand, tripod, bracket, or table. The video
product may fall, causing serious injury to a child or adult
as well as serious damage to the video product. Use this
3
video product only with a cart, stand, tripod, bracket, or
table recommended by the manufacturer‘s or sold with the
video product. Any mounting of the product should follow the
manufacturer‘s instructions and use of a mounting accessory
recommended by the manufacturer.
11a. A video product and cart combination should be moved
with care. Quick stops, excessive force, and uneven surfaces may cause the video product and cart combination to
overturn. Note to CATV system installer This reminder is provided to call the CATV system installer‘s attention to Section 820-40 of the NEC which provides guidelines for proper
grounding and, in particular, specifi es that the cable ground
shall be connected to the grounding system of the building,
as close to the point of cable entry as practical.
12. Outdoor Antenna Grounding- If an outside antenna or
cable system is connected to the video product, be sure
the antenna or cable system is grounded so as to provide
some protection against voltage surges and built-up static
charges. Section 810 of the National Electrical Code, ANSI/
NFPA No.70-1984 (Section 54 of Canadian Electrical Code,
Part1) provides information with respect to proper grounding
of the mast and supporting structure, grounding of the lead-in
wire to an antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
13. Power Lines-An outside antenna system should not be
located in the vicinity of overhead power lines, other electric
light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching
or approaching such power lines or circuits, as contact with
them might be fatal. Installing an outdoor antenna can be
hazardous and should be left to a professional antenna
installer.
14. Cleaning- Unplug this video product from the wall outlet
before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
15. Objects that may touch dangerous voltage points or
„short-out“ parts could result in a fi re or electric shock. Never
spill liquid of any kind on the video product.
16. Lightning-For added protection for this video product
during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet
and disconnect the antenna or cable system. This will prevent damage to the video product due to lightning and power
line surges.
17. Servicing-Do not attempt to service this video product
yourself, as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to
qualifi ed service personnel.
18. Conditions Requiring Service-Unplug this video product
from the wall outlet and refer servicing to qualifi ed service
personnel under the following conditions:
A.When the power-supply cord or plug is damaged.
B.If liquid has been spilled, or objects have fallen into the
video product.
C.If the video product has been exposed to rain or water.
D.If the video does not operate normally by following the
operating instructions.
Adjust only those controls that are covered by operating
instructions. Improper adjustment of other controls may
result in damage and will often require extensive work by a
qualifi ed technician to restore the video product to its normal
operation.
E.If the video product has been dropped or cabinet has been
damaged.
F.When the video product exhibits a distinct change in performance-this indicates a need for service.
19. Replacement Parts-When replacement parts are
required, have the service technician verify that the replacements he uses have the same safety characteristics as the
original parts. Use of replacements specifi ed by the video
product manufacturer can prevent fi re, electric shock, or
other hazards.
20. Safety Check-Upon completion of any service or repairs
to this video product, ask the service technician to perform
safety checks recommended by the manufacturer to determine that the video product is in safe operating condition.
21. Wall or Ceiling Mounting- The product should be
mounted to a wall or ceiling only as recommended by the
manufacturer.
22. Heat-The product should be situated away from heat
sources such as radiators, heat registers, stoves, or other
products (including amplifi ers) that products heat.
► SAFETY INFORMATIONS
4
FRONT PANEL
REAR PANEL
► INTRODUCTION
5
► REMOTE CONTROL
6
► SYSTEM CONNECTION
GENERAL
There are many different types of TV/VCR and other equipment that you can connect to the STB.
In this manual you will see some of the most common ways to connect your equipment.
7
Loading...