INSTALLATION INSTRUCTIONS
SQ and SQW trim
Upon receipt, thoroughly inspect for
any freight damage which should be
brought to the attention of the delivery
carrier. Compare the catalog
description listed on the packing slip
with the label on the carton to ensure
that you have received the correct
merchandise.
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
SAVE THESE INSTRUCTIONS
NEW INSTALLATION FOR SQ TRIM
1. Remove trim from upper reflector by gripping flange and pulling out.
2. Using a screwdriver, push (4) clips in and move towards center of upper reflector (See Figure 1).
3. Thread socket cup through hole in upper reflector (See Figure 2).
4. Attach upper reflector to housing by insertin g retent ion scr ew int o keyhole slo t, do not tighten (S ee
Figure 3). For wallwash reflectors, make sure to orient wallwash kicker toward wall to be illuminated
(See Figure 6).
5. Reposition spring clips to engage both the slots in the upper reflector and mounting frame (See
Figure 4).
6. Tighten screw until spring clips are tight against slot in mounting frame. DO NOT OVER TIGHTEN
(See Figure 4).
7. Attach socket cup to upper reflector by engaging screw heads in ke yhole slots and tighten unti l
snug. Screw heads must be fully engaged in slots in order for the lower tr im to be installed (See
Figure 5).
8. Install lamp ensuring that correct type and wattage are used.
9. Attach safety chain to lower trim.
10. Install lower trim by aligning retention tabs with springs located in upper reflector. Push lower trim
into upper reflector ensuring that it is fully engaged.
WALLWASH TRIM ORIENTATION
Follow steps 1-10 from NEW INSTALLATION FOR SQ TRIM
11. Install lower trim by aligning retention tabs with springs located in upper reflector. The shor t side
of the trim must be aligned with the wallwash kick er (Figure 6). Push lower trim into upper ref lector
ensuring that it is fully engaged.
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
1. Electric current can cause painful
shock or serious injury unless
handled properly. For you safety,
always remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp
surface, or in water
2. Specific safety information
concerning lamps:
• Match wattage of fixture and lamp
exactly.
• Do not remove or insert lamp when
power is on.
• Do not scratch glass or su bject lamp
to undue pressure as either may cause
lamp breakage.
• Protect operating lamp from sources
of moisture.
• If lamp is marked it contai ns
mercury. Follow disposal laws. See:
www.lamprecycle.org
.
Retention
screw
Figure 1 Figure 2
Spring clips (4)
Figure 3
Wallwash
kicker
Align short
side with
kicker
Figure 5
Figure 4
Orient toward wall
Figure 6
©2009 Acuity Brands Lighting, Inc.
CJ5200040 Rev. B
2/10 1 of 1
All Rights Reserved.
Loading...