Gotham Candéo LED PDLFV User Manual
INSTALLATION INSTRUCTIONS
Candéo® LED
PDLFV Reflector
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure that you have received
the correct merchandise.
SAVE THESE INSTRUCTIONS
New Installation for PDLFV
1. Pull down on flange to remove trim (see Figure 1).
2. If required, make inner reflector height adjustments by loosening the three
screws attaching it to the outer reflector, selecting a slot and re-tightening
screws (see Figure 1).
3. Attach socket cup to top of inner reflector by aligning spring clip on socket cup
with alignment arrow on inner reflector (see Figure 2).
4. Slide socket cup onto reflector neck until top of reflector embosses meet the
top of the slots in the socket cup.
5. Twist socket cup clockwise until spring clip locks into place (see Figure 2).
6. Plug in phone cord from LED driver located on housing (see Figure 3).
7. Push reflector through mounting frame opening and align key hole slots with
screws in trim mounting brackets. Rotate reflector to engage in slots and tighten
screws. (WARNING: Key hole slots are located behind LED board. When aligning screws, be careful not to damage board) (see Figure 4).
8. Install trim.
9. Install compact fluorescent lamp.
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
WARNING - Risk of fire. Do not install insulation within 3 inches of fixture sides or wiring
compartment, nor above the fixture in such
a manner as to entrap heat.
1. Electric current can cause painful shock
or serious injury unless handled properly.
For your safety, always remember the following:
• Turn off the power supply.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface, or in water.
• Double check all electrical connections
to be sure they are tight and correct.
2. Specific safety information concerning
lamps:
• Match wattage of fixture and lamp ex-
actly.
• Do not remove or insert lamp when power
is on.
• Do not scratch glass or subject lamp to
undue pressure as either may cause
lamp breakage.
• Protect operating lamp from sources
of moisture.
Height Adjustment
Loosen Screws (3)
To Adjust Height
Figure 1
Figure 3
THGIL
DNA
Slots
Inner
Reflector
ivynarofkcehC
motpmySesuaCelbissoPnoitcAevitcerroC
OTSLIAFPMAL
TUOSEOGPMAL
GNITHGILRETFA
NOSELCYCPMAL
FFO
Outer
Reflector
Flange
TRAHCGNITOOHSELBUORT
omrotiucricnirorregniriW·
pmalytluaF·
tuptuotsallabroeniL·
tsallabytluaF·
pmalytluaF· naht
wolooterutarepmettneibmA·
erutxifotesolcootsinoitalusnI·
hgihootegattawpmaL·
wolegatlovtuptuotsallaB·
Slots
Embossments
Figure 2
12" Phone Card
Align Keyhole Slots
with Screws
Figure 4
.snoitcaevitcerrocdnasesuacelbissopfotsilgniwollofeht
For LED trouble shooting, contact Gotham Technical Support.
dezigrenetonerutxifehtgnideeftiucriC·
noitcennocelud
.tcerroc
.enowenahtiw
ehC·
enilkcehC·
.ytiunitnoctiucrickc
.gnisuohnideificepsegattawpmalllatsnI·
Spring Clip
Stamped
Arrow
rehtarmotpmyssihttibihxelliwpmalayllanoisaccO·
.pmalwenaetutitsbuS.thgilotgniliafylpmis
)"3tsaelta(eludomdnuoramorfnoitalusnievomeR·
Screws
renesitiucrictahterusneotesufrorekaerbtiucrickcehC·
erasnoitcennoctahterusneotxobecilpserutxifenimaxE·
.egatlovtiucricnepokcehC.erutxiftaegatlovenilkcehC·
nimelborpehtetacol,noitidnocdoognimeesyehtfI.eludomni-emarfropmalehtotegamadelbis
.dezig
ylbareferp,pmalrehtonaetutitsbusdnapmalytluafehtevomeR·
lanigiroehtecalper,sthgilpmalehtfI.thgilotnwonksitahteno
.snoitidnoclatnemnorivnegnitsixetsniagagnitartsallabkcehC·
.egatlovtiucricnepokcehC.erutxifehttaegatlov
Part No. CJ520743
©
2006 Gotham 10/06
Loading...