Page 1
Steering Wheel (07-0004)
1: Place the Steering Wheel Insert inside the Steering Wheel.
2: Use the 2-1/2" lag screw and washer to fasten the Steering Wheel to the board. Do
not over-tighten the lag screw or the Steering Wheel will not turn.
(Note: board must be at least 2" thick so that the lag screw does not penetrate the
other side.)
3: Place the Steering Wheel Cap over the center of the Steering Wheel and snap it into
the Steering Wheel Insert.
Steering Wheel
(11-1/2" diameter x 3-1/2" deep)
(Grip is 1" diameter)
2"
Minimum
4 x 4 board shown
(not included)
Steering Wheel Insert
Washer
(20mm o.d. x 10.5mm i.d)
Lag Screw
(9.5mm o.d. x 62mm L)
Steering Wheel Cap
Please note: Steering Wheel is intended for make-believe-play by children.
*FOR RESIDENTIAL USE ONLY*
*FOR CHILDREN AGES 3-11*
Loading...