Go Rhino DOMINATOR SERIES, D24097 Assembly/installation Instructions

REV/B

QTY PARTS DESCRIPTION

12 3/8” X 2” HEX BOLTS
24 3/8” HEX NUTS
24 3/8” LOCK WASHERS
48 3/8” FLAT WASHERS

QTY

12

4
2
1
1

PARTS DESCRIPTION

3/8” X 1” HEX BOLTS
D02 FRONT AND REAR MOUNTING BRACKETS
D03 CENTER MOUNTING BRACKETS
D24097P PASSENGER SIDESTEP
D24097D DRIVER SIDESTEP

INSTALLATION INSTRUCTIONS

Read the instructions completely before you begin the installation.
If your vehicle is equipped with factory running boards, remove the boards, brackets and fasteners.
This installation uses (3) mounting brackets per side, and requires drilling (2) holes in the lower body
pinch mold for each bracket.
It is the installer’s responsibility to confirm all measurements and that there are no obstructions such as
brake, fuel or electrical lines before drilling.

Step 1. Beginning with the passenger side measure reward from the front fender bolt (refer to diagram for
dimensions) and scribe (6) vertical lines on the body pinch mold.

DOMINATOR SERIES SIDESTEPS

ASSEMBLY & INSTALLATION INSTRUCTIONS

PART NO. D24097 02-08 DODGE RAM QUAD CAB

Do not attempt to install this product on any vehicle other than the one it is designed for and listed above!

Step 2. Measure up from the bottom edge of the pinch mold 7/16” and scribe intersecting lines.

Step 3. Confirm the measurements, center punch and drill 3/8” holes through the body pinch mold.

Repeat the above steps for the driver side.

REAR OF VEHICLE

D02 MOUNTING BRACKETS

D03 MOUNTING BRACKET

D24097P PASSENGER SIDESTEP

FRONT FENDER BOLT