Go Rhino D24051 Installation Instructions Manual
Qty
Part Description
1
8mm x 2 5mm H ex B olt
10
5/16” U-Nut
10
5/16” x 1” Hex B olt
11
5/16” Flat Washer
1
3/8” T-Bolt
12
3/8” x 1 ¼” Hex Bolt
13
3/8” Lock Washer
Qty
25
3/8” Flat Washer
13
3/8” Hex Nut
1
C0912 Passen ger Front Bracket
2
C0922 Passen ger Center & Rear Bracket
1
Vinyl Gasket
1
D24050P Passenger Sid e S tep
1
D24050D Driver Si de St ep
INSTALLATION INSTRUCTIONS
DOMINATOR II Series SideSteps Part Number D24051 (B-PS)
2011-12 Chevrolet Silverado / GMC Sierra 2500HD, 3500HD Crew Cab P/U 2/4WD (Diesel)
Do not attempt to install this product on any vehicle other than the one it is designed for and listed above!
Parts List
11 5/16” Lock Washer
Tool Required:
½”, 9/16” & 13mm Socket
½”, 9/16” & 13mm Wrench
3/16” Hex Key
3 C0921 Driver Front, Center & Rear Br acket
Ratchet & Ratchet Ext ensi on
Approximate installation time: 45min
Installation
Read the installation instructions completely and verify that all of the parts listed are accounted for.
Step-1 This installation uses three mounting brackets per side. Begin by installing the passenger side front
bracket. M eas ur e from the fron t f en der bol t rear ward appr oxi mately 14”, locate the hole in the body pinc h mol d
and install (1) 5/16” U-Nut as show n. Photo #1 & #2
Step-2 Locate in front of the urea tank the plastic plug in the body rocker panel. Remove the plug, Install the vinyl
#1
#2
#5
#6
#3
#4
gasket over the threads of the 3/8” T-Bolt and install T-Bolt in the rocker panel as shown. Photo #3 & #4
Step-3 From the front of the urea tank, position the front mounting bracket between the tank and the body pinch
mold. Slide the bracket rearward and align the holes in the bracket with the T-Bol t an d U-Nut. Photo #5 & #6
Step-4 Position th e hole in the front o f th e br ack e t over the T-Bolt and install (1) 3/8” flat washer, (1) 3/8” lock
washer and (1) 3/8” hex nut. Align the hole in th e flange of the bracket with the U -Nut and install (1) 5/16” flat
Loading...