Go Power! GP-SW1600 User Manual
Pure Sine Wave Inverter
GPSW-600
GPSW-1500
________________________________________________
Owner’s Manual
GPSW-600/1500
___________________________________________________________
Table of Contents
Introduction 2
Specifications 3
Name and Main Function 5
Installation 9
Operation 11
Operating Limits 12
Troubleshooting 13
Maintenance 14
Disclaimer of Liability and Warranty 15
Configuring your GPSW-600/1500 18
1. Introduction
The Go Power! Sine Wave series models are used in a wide range of
applications including remote homes, RVs, sailboats and powerboats. It will
operate most televisions and VCRs, personal computers, small appliances and
tools such as drills, sanders, grinders, mixers and blenders.
The inverter must have a greater power rating then the load it provides
power to.
To get the most out of the power inverter, it must be installed and used properly.
Please read the instructions in this manual before installing and using this model.
2
GPSW-600/1500
___________________________________________________________
2. Specifications
2.1 1500 W Inverter
SPECIFICATIONS
Continuous Output Power 1500 W
Surge Rating 2000 W
Output Waveform Pure Sine Wave <3% THD
Output Voltage ± 5% 115 VAC RMS
Input Voltage 11 – 16.0 VDC 21.0-30.0
Efficiency 85-90%
No Load Current Draw / Powersave 1.0 A / 0.1A 0.65 A / 0.05 A
Protection
Low Battery Alarm ± 2% 10.5 V
Low Battery Shut-Down ± 2% 10.0 V 20.0 V
Operating Temperature Range 0 - 40ºC / 32ºF - 104ºF
Storage Temperature Range -30ºC - 70ºC / -22ºF - 158ºF
Cooling Thermostatically Controlled Fan
AC Receptacle Dual GFCI
Remote Port Option Yes
Dimensions (L x W x H) in mm 419 x 279 x 102
Dimensions (L x W x H) in inches 16.3 x 10.9 x 4.1
Weight 7.7 kg / 17 lbs
Warranty 2 Years
GPSW-1500 (12V)
Overload, Short Circuit, Reverse Polarity (Fuse),
Over/Under Input Voltage, Over Temperature
GPSW-1500 (24V)
21 V
Inverter Install Kits GP-DC-KIT3 GP-DC-KIT2
UPC 8-39085-00001-4 8-39085-00039-7
3
GPSW-600/1500
___________________________________________________________
2.2 600 W Inverter
SPECIFICATIONS
Continuous Output Power 600 W
Surge Rating 860 W
Output Waveform Pure Sine Wave <3% THD
Output Voltage ± 5% 115 VAC RMS
Input Voltage 10.5– 15 VDC 21.0-30.0
Efficiency 85-92 %
No Load Current Draw / Powersave 0.90 A 0.50 A
Protection
Low Battery Alarm ± 2% 10.7 V
Low Battery Shut-Down ± 2% 10.3 V 20.6 V
Operating Temperature Range 0 - 40ºC / 32ºF - 104ºF
Storage Temperature Range -30ºC - 70ºC / -22ºF - 158ºF
Cooling Thermostatically Controlled Fan
AC Receptacle Dual GFCI
Remote Port Option Yes
Dimensions (L x W x H) in mm 295 x 180 x 72
Dimensions (L x W x H) in inches 11.6 x 7.1 x 2.8
Weight 2.7 kg / 5.9 lbs
Warranty 2 Years
GPSW-600 (12V)
Overload, Short Circuit, Reverse Polarity (Fuse),
Over/Under Input Voltage, Over Temperature
GPSW-600 (24V)
21.4 V
Inverter Install Kits GP-DC-KIT2
UPC 8-39085-00007-6 8-39085-00018-2
4
GPSW-600/1500
___________________________________________________________
3.0 Name and Main Function
3.1 Front View GPSW-1500
a) ON / OFF switch:
Power ON/OFF switch, leave in the OFF position during installation.
b) OVP: over voltage protection.
c) UVP: under voltage protection
d) OTP: over temperature protection.
e) OLP: over load protection.
f) BATT. VOLTS: display battery voltage.
g) LOAD WATTS: display AC load watts.
h) AC outlet: Ground Fault Protected (GFCI)
5
GPSW-600/1500
___________________________________________________________
3.2 Rear View GPSW-1500
Warning! Operation of the inverter without a proper ground connection
may result in an electrical safety hazard.
a) Ventilation ports:
Do not obstruct, allow at least 1 inch for air flow.
b) Battery terminals:
Connect to 12V / 24V battery or other 12V / 24V power source. [+] is positive
[ - ] is negative. Reverse polarity connection will blow the internal fuse and
may damage inverter permanently.
c) RS-232 jack.
d) Chassis ground or to vehicle chassis using # 8 AWG wire.
6
Loading...