Go-Ped Sport, Liquimatic Instruction Manual

Copyright 1999 Patmont Motor Werks. All Rights Reserved.

California

Instruction Manual

for Sport®

and Liquimatic®

GO-PED®ACCESSORIES LIST GO-PED®PARTS LIST

PART#

DESCRIPTION

PART#

DESCRIPTION

9058 Canvas Carry Bag 1001 Frame
9061 Tool Kit 1002 Latch Assembly
9062 Go-Mix (Go-Ped Oil Pack) 1006 Wooden Deck
9063 Go-Ped T-Shirt (M,Lg,XLg) 1007 Deck Hardware Kit

1013 Drive Spindle
1014 Drive Spindle Belt
1018 Engine Hardware Kit
1019 Frame / Muffler Connect Tube
1021 Gas Tank Hardware Kit
1022 Handle Lock Tube
1027 Front Fork
1028 Front Fork Bearing Kit
1030 Front Brake Caliper
1031 Front Axle Assembly
1032 Quick Release Axle Assy.
1034 Kick Stand
1039 Wheel Bearings
1043 Handle Hinge FTG Assembly
1046 “T” Handle
1047 Brake Lever Assembly
1049 Grip Set
1050 Throttle Cable Assembly
1051 Throttle Lever
1053 Plastic Cable Tie Set
1054 Brake Cable Assembly
1056 Handle Hinge Pin
1059 Wheel & Tire Assembly
1062 Automatic Safety Spring &

Grip Kit

3114 Enduro T ank
3116 Gas Cap
3120 Fuel Filter Assembly

GO-PED®FRAME PARTS

3114

1019

1032

1034

1006

1027

1001

1059

1030

1022

1050

1062

1054

1051

1049

1046

1047

OIL & FUEL INFORMATION

The Go-Ped® has a two-stroke engine that requires oil to
be mixed with the gasoline.Use a high quality two-cycle oil
that is formulated for small air-cooled engines.Go-Mix® oil
comes in gallon and tank size packets for a proper mix
every time. Go-Mix is available from your authorized Go­Ped® reseller and is the factory recommended oil for the all
two stroke Go-Ped® products.

OIL AND FUEL MIXING INSTRUCTIONS

NOTE:

For proper engine operation and maximum reliabil­ity, pay strict attention to the oil and fuel mixing instructions.
Use a 40:1 fuel/oil ratio. Using improperly mixed fuel can
severely damage the engine .Use the following procedure to
ensure complete mixing:

1. Put a small amount of fresh gasoline into a clean 1 (U.S.)

gallon (3.785 liter) fuel can.

2. Add 3.2 ounces of 2-cycle oil.

3. Fill the remainder of the fuel can with gasoline (1 gallon).

4. Screw the fuel can cap on tightly and SHAKE THE CAN

VIGOROUSLY FOR 30 SECONDS.

Technical Support Hotline [phone]

ENGINE PARTS FOR G23-LH ENGINE

Index Part # Description Index Part # Description

4800 Engine 41 4041 Crankshaft Complete
1 4001 Cylinder 44 3044 Flywheel Nut
2 4002 Muffler Bolt 45 4045 Cover Screw
3 4003 Cylinder Gasket 54 4054 Flywheel
4 4004 Cylinder Screw 55 4055 Ignition Coil
5 4005 Insulator Gasket 58 4058 Coil Screw
6 4006 Insulator Manifold 59 4059 Cord Complete
7 4007 Carburetor Gasket 60 4060 Grommet
8 4008 Insulator Screw 61 4061 Coil Screw
9 3009 Carburetor Screw 66 3066 Spar k Plug

11 4011 Muffler Gasket 67 4067 Starter Assy
12 4012 Muffler 76 4112 Cap (plug)
16 4016 Crankcase 77 4113 Spring
18 4018 Crankcase Gasket 79 4079 Starter Screw
19 4019 Oil Seals Set 81 4115 Cap (seal)
20 3020 Main Crank Bearing Set 88 4088 Carburetor Assy.
21 3021 Snap Ring 107 3107 Cleaner Assy.
22 3022 Flywheel Key 108 3108 Filter Screen
23 4023 Crankcase Screw 109 3109 Air Filter
26 4026 Fan Cover 110 3110 Cover Cleaner
32 4032 Fan Cover Screw 3114 Gas Tank Assy.
33 4033 Engine Cover 111 3111 Rear Filter Housing
34 4034 Cover Screw 112 3117 Gas Cap Packing
35 3035 Piston 116 3116 Gas Cap Assy.
36 3036 Piston Rings Set (2) 3123 Kill Switch
37 3037 Piston Pin 3120 Fuel Filter
38 3038 Snap Ring Set
39 3039 Pin Bearing
40 3040 Pin Washers

BE SURE TO READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO START
OR OPERATE THIS UNIT.

Using old or improper fuel, or improperly mixing the oil
and fuel can cause engine damage.This type of damage
will void engine warranty.