GoPass AVL-900R, AVL-900 Quick Start Manual
Q
Q
A
A
uii
u
V
V
c
c
L
L
k
k
-
9
-
9
Stt
S
0
0
arrtt
a
0
0
(
(
G
G
R
R
uii
u
)
)
d
e
d
e
AVL-900(R) Hardware Quick Installation Guide
1. Precaution before Installation
z Check if all the parts are included.
z Pre pare a SIM card for GSM communication. Use some other mobil e phone to
confirm that the PIN code has not been set, and that it can dial out and receive
telephone calls without pr ob le m.
z Before install the SIM card, make sure to cut off power from the AVL unit. The
correct installation method is to push the tray completely into the AVL unit, until
you feel it is hooked by something.
z It takes longer time (over 20 minutes) to get a position fix for the very first
time positioning.
z The factory default password is “8888”.
2. Panel Description
1
3. Installation
Step 1: Install GPRS Antenna
Connect the GPRS Antenna to the unit.
Fasten the connection by turning the screw in the bottom.
Please do not swing round the antenna itself.
Step 2: Install SIM Card
(1) Unscrew and remove the back cover of the device. Push the holder top upward to
loose it.
(2) Insert the SIM card by sliding it into the card holder slot, with the chip module facing to
the connectors on PCB, as shown in the picture.
(3) Flip down the holder top. Push the holder top leftward, and let it snap in completely.
Step 3: Connect GPS Antenna
GPS antenna is used to receive satellite signals in
the sky. It should be positioned at a place where it
will have an unobstructed view of the sky, such as
the metallic winds hield.
If your car is w ith me ta llic win dshield, p lease cu t a ho le
on the windshield above the place where you put the
GPS antenna, so that the antenna can receive the GPS signals.
Step 4: Connect to the power source, and turn on the unit
Step 5: Check if GPS can works properly
※ Method：When GPS has got position fix, the GPS LED will
turn from constant glow to “blinking light”. Check if the GPS
LED has turned t o “blinking light”.
2
4. Power Charging
Note: Microphone jack wi ll be LOCK once connecting to Vehicle Tracker.
¾ Method 1: Connect car charger to the car cigarette light er directly.
¾ Method 2: Connect the USB cable to the back-up battery.
¾ Method 3: Connect to the wire with permanent power, such as the wire for
turning lights...
Voltage: 9V~30V
* This should be done by the professional technician.
3
Loading...