Google A1JT User Manual

REGULATORY INFORMATION

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this product not authorized by Google could void the
electromagnetic compatibility (EMC) and wireless compliance and negate your authority
to operate the product.

Important:
This product has demonstrated EMC compliance under conditions that included the use
of compliant peripheral devices and shielded cables between system components. It is
important that you use compliant peripheral devices and shielded cables between
system components to reduce the possibility of causing interference to radios,
televisions, and other electronic devices.

Radio Frequency Exposure

This device meets the U.S. Federal Communications Commission's (FCC) requirements
for exposure to radio waves and is designed and manufactured not to exceed the FCC's
emission limits for exposure to radiofrequency (RF) energy. To comply with FCC RF
exposure compliance requirements, this device must not be co-located or operating in
conjunction with any other antenna or transmitter.

!