GOODWOOD AUDIO The TX Interfacer, The Interfacer User Manual

THE INTERFACER

MANUAL

1. Right in

8

1

2

3

4

5

2. Tuner send (directly

9

below Right in)

3. Press in for ground lift

– Right out*

4. Press in for phase

10

inversion – Right out*

5. Left in

6. Passive out

6

7

11

7. Buffered out

12

* Ground lift and phase inversion available on TX version only

†

Phase only functional when TX button is pressed in

13

14

8. RGB LED – red = stereo,

blue = mono

9. Right out

10. Left out

11. Passive in

12. Soft touch switch –

†

press to mute,
hold to sum

13. Buffered in

14. VDC centre negative

only – mA

The Interfacer is all about professionalism. It’s about setting your
board up like the pros to be ready for any situation. Two amps. One
amp. Ground loops. Phase issues. Long cable runs. Buffer sensitive
pedals. The Interfacer handles all of these scenarios with ease. It
even has a master mute for when the proverbial hits the fan. Think
of it as a Swiss Army knife for your pedal board, except it’s made in
Australia, it’s black, and it’s a guitar pedal.

Let’s look at the most common way of connecting The Interfacer.

TUNER

AMP

STEREO WET PEDALS

(modulation, delay

reverb etc.)

AMP

DRY PEDALS

(compression, fuzz,

overdrive etc.)

GUITAR