Good Way Technology TD1110Z1 Users Manual

TD1110Z1

Z-Wave Window/Door Detector

User’s Manual

ABOUT THIS MANUAL

This manual is designed for use with the Z-Wave Window / Door Detector. Information in this
document has been carefully checked for accuracy; however, no guarantee is given to the
correctness of the contents. The information in this document is subject to ch ange without notice.
The manufacturer does not make any representations or warranties (implied or otherwise)
regarding the accuracy and completeness of this document and shall in no event be liable for
any loss of profit or any commercial damage, including but not limited to special, incidental,
consequential, or other damage.

SAFETY INSTRUCTIONS

Always read the safety instructions carefully:

 Keep this User’s Manual for future reference
 Keep this equipment away from humidity
 If any of the following situation arises, get the equipment checked by a service technician:

• The equipment has been exposed to moisture.

• The equipment has been dropped and damaged.

• The equipment has obvious sign of breakage.

• The equipment has not been working well or you cannot get it to work according to the

User’s Manual.

COPYRIGHT

This document contains propriet ary information protected by copyright. All right are reserved. No
part of this manual may be reproduced by any mechanical, electronic or other means, in any
form, without prior written permission of the manufacturer.

TRADEMARKS

All trademarks and registered trademarks are the property of their respective owners or
companies.

i

a. for FCC 15b devices

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

b. FCC Part 15.21 information for user

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your

authority to operate the equipment.

c. for mobile devices without co- lo cation condition

located more than 20cm away from the body of user and near by person )

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment

should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

( the transmitting antenna is installed or

Table of Contents

1. Introduction............................................................................................................1

Features.............................................................................................................................2

Package Contents..............................................................................................................3

LED Indicator ...................................................................................................................3

Z-Wave..............................................................................................................................4

Wireless Range..................................................................................................................5

2. Installation..............................................................................................................6

Hardware Connection ....................................................................................................... 6

Product Description...........................................................................................................8

Installation Requirements ............................................................................................... 14

Installing the Z-Wave Window / Door Detector.............................................................14

3. Specifications.......................................................................................................19

4. Regulatory Compliance.......................................................................................21

FCC Conditions ..............................................................................................................21

WEEE Information .........................................................................................................21

ii

1. Introduction

This detector enables you to detect when your window/door is opened or closed. This

detector allows you to assign lights or appliances to turn on and off when the attached

window/door is being opened or closed. You can monitor any window/door status in

your home through PC connectivity using a Z-wave USB dongle when you are away

from home.

1