GVC-2200-V Operation & Maintenance Manual
2.4 Safety Regulations
2.4.1 Usage – The Goodway’s Vapor-Steam Cleaner must be used only for its
designated purpose: a steam generator with cleaning accessories. The
Vacuum must not
be used for any other purposes other than those described
in this manual; i.e. it is not designed to pick up general dirt. Goodway
Technologies Corp.. will not be held liable for any damages caused from
improper, incorrect or unreasonable use.
2.4.2 Power Supply - Before connecting GVC-2200-V, check that the data on the
voltage rating plate are the same as the main electrical supply. The rating plate
is found at the rear of the GVC-2200-V. Goodway’s Vapor-Steam Cleaner
MUST BE GROUNDED. Use of a Ground Fault Circuit Interrupter (GFCI) for
additional safety is strongly recommended.
2.4.3 The following rules must
be observed when using the GVC-2200-V:
never use barefooted, or in wet conditions,
never use power supply extension cables without appropriate safety marks
(UC, CSA, etc.),
always check daily before use that the power supply cable, plug and sockets
(including any extension cables) are in good condition; check for visible
signs of damage (and do not use if damaged or faulty).
never pull at the power supply cable, and never allow it to rub against sharp
edges, or get caught between doors or drawers; protect the cable from heat,
stress and moisture, and route away from paths/work areas.
never allow children or inexperienced, untrained, or unauthorized persons
access to the GVC-2200-V,
never leave unattended when in use,
never leave it unprotected from adverse weather conditions (rain, ice, etc.),
never allow any part of to be immersed in liquid,
always ensure the GVC-2200-V is kept upright, even when not powered on,
never top up the water in the canister without following the recommended
procedures,
never empty the recovery tank without following the recommended
procedure.
2.4.4 Use only authorized parts, components and accessories with this appliance
obtainable through Goodway Technologies Corp.
2.4.5 Always unplug at the power supply:
- before emptying the boiler,
- before cleaning or servicing,
- before parts are exchanged or removed,
- when emptying the recovery tank
- when refilling the water and chemical canisters
GVC-2200-VVAC Page 4 of 16 August 22, 2002