Goodway BU3110 User Manual

User’s Manual

USB 3.0 Single Port Express Card

ABOUT THIS MANUAL

This manual is designed for use with the USB 3.0 Single Port Express Card.
Information in this document has been carefully checked for accuracy;
however, no guarantee is given to the correctness of the contents. The
information in this document is subject to change without notice. The
manufacturer does not make any representations or warranties (implied or
otherwise) regarding the accuracy and completeness of this document and
shall in no event be liable for any loss of profit or any commercial damage,
including but not limited to special, incidental, consequential, or other
damage.

SAFETY INSTRUCTIONS

Always read the safety instructions carefully:
Keep this User’s Manual for future reference.
Keep this equipment away from humidity.
If any of the following situations arises, get the equipment checked by a

service technician:
The equipment has been exposed to moisture.
The equipment has been dropped and damaged.
The equipment has obvious sign of breakage.
The equipment has not been working well or you cannot get it to work

according to the User’s Manual.

COPYRIGHT

This document contains proprietary information protected by copyright. All
right are reserved. No part of this manual may be reproduced by any
mechanical, electronic or other means, in any form, without prior written
permission of the manufacturer.

1

Table of Contents

1. Introduction ................................................................................................................... 3

Features...........................................................................................................................4

Package Contents ........................................................................................................... 4

System Requirements......................................................................................................4

2. Installation ..................................................................................................................... 5

3. Installation Verification.................................................................................................9

4. Notice ........................................................................................................................... 10

5. Uninstall the Driver...................................................................................................... 11

6. Specifications.............................................................................................................. 13

7. Regulatory Compliance .............................................................................................. 14

FCC Conditions ............................................................................................................. 14

CE.................................................................................................................................. 14

WEEE Information.........................................................................................................14

2

1. Introduction

This new product mainly is to fit in the market demand with low cost and flexibility
for user benefit. Also, it will bring higher efficiency and advantageous to user
with integrating Super Speed USB transceiver as will as PCI Express transceiver.
Moreover, an additional independent DC power Jack will allow to add in a 500
mA to ensure the USB 3.0 output will working with high reliability.

Features

 Compliant with USB 3.0 Specification Revision 1.0
 Compliant with Extensible Host controller interface (xHCI) Specification

Revision 0.96

 Single USB port supporting SS/HS/FS/LS data rates

(5 Gbps/480M bps/12M bps/1.5M bps)

 Single PCI Express Lane
 Supports PCI Express Specification Revision 1.1

3

 Supports PCI bus Power Management Interface Specification Revision 1.2
 10 MHz/ 30 MHz crystal system clock
 Additional DC Jack to enhance the function stability
 Integrated Super Speed USB Transceiver
 Integrated PCI Express Transceiver

Package Contents

 USB 3.0 single Port Express Card x1
 Driver CD (Driver and User’s Manual) x1
 Quick Installation Guide x1
 DC to USB cable (60 cm) x1

System Requirements

 OS Compliance: Windows® 7, Windows Vista®, Windows® XP, Linux
 Application Compliance: PCI Express Card Specification 1.0

2. Installation

1. Insert USB 3.0 Single Port Express Card to PCI-Express slot.

USB 3.0 Port

DC Power Jack

2. The “Found New Hardware Wizard” Window will appear, please click
“Cancel”.

4