Good Water Warehouse GOLDLINE-50 Installation & Service Manual

Good Water Warehouse Inc.
1700 E Walnut Ave
Fullerton CA 92831
[phone]
[phone] FAX

Reverse Osmosis System

Installation & Service Guide

Model # GOLDLINE-50

System Conforms to NSF/ANSI Standard 58

for Performance Class

System Tested and Certied by NSF International against NSF/ANSI Standard 58 for the

reduction of the claims specied on the Performance Data Sheet (page 3)

System Tested and Certied by NSF In­ternational against NSF/ANSI Standard

58 for the reduction of the claims speci-

ed on the Performance Data Sheet (Page 3)

Please read this manual carefully

before attempting installation.

(1)

(3)

Goldline Manual Introduction

The Goldline RO System conforms to NSF/ANSI Standards 58

for performance claims as veried and sustained by test data. All pre and

post ltration demands were removed prior to contaminant reduction

performance testing by the Water Quality Association laboratory.

The Goldline reverse osmosis drinking water system is designed for easy installation and maintenance. You will insure a successful
installation as well as reliable operation by carefully reading this manual and following the operational guidelines. Please note
that routine maintenance is essential to the longevity and performance of the system. Filters should be changed every six months
(see below) depending on the quality of the feed water supply. The Goldline RO installation should comply with all state and
local laws and regulations. Manufacturer recommends a TDS test every six months. This system is acceptable for treatment of
inuent concentrations of no more that 27 mg/L nitrate and 3 mg/L nitrite in combination measured as N and is certied for nitrate/
nitrite reduction only for water supplies with a pressure of 40 psig or greater. This reverse osmosis system contains a replaceable
component critical to the efciency of the system. Replacement of the reverse osmosis component should be with one of identical
specications, as dened by the manufacturer, to assure the same efciency and contaminant reduction performance.

Necessary Installation Tools

Recommended Filter & Membrane

Replacement Schedule

• Variable speed drill • Teon tape

• Relton Drill • Small knife

• 1" hole saw • Phillips screw driver

Filter/Membrane Part # Frequency

Sediment 93023 6 months

Carbon Block Prelter 32-250-125-975 6 months

Carbon Postlter CL10ROT40-B 6 months

* RO Membrane 1204694 2-5 years

Conditions for operation of TFC - Thin Film Composite Membrane

Used in the Goldline-50

Source Water Supply - TFC

Community / Private Bacteriologically Safe

System Pressure min/max 30 / 100 psi

Temperature 4º / 38ºC (40º / 100º F)

pH Range 3.0 to 11.0

Maximum supply TDS

level

Turbidity < 1.0 net turbidity (NTU)

1

Efciency rating means the percentage of the inuent water to the
system that is available to the user as reverse osmosis treated water
under operating conditions that approximate typical daily usage

1800 mg/L

Test parameters: 25º± 1ºC, 50 psi and pH of 7.5

2

Recovery rating means the percentage of the inuent water to the
membrane portion of the system that is available to the user as reverse
osmosis treated water when the system is operated without a storage
tank or when the storage tank is bypassed.

Chemical Parameters - TFC

Hardness (CaCo3)

Iron (Fe) < 0.1 mg/L

Manganese (Mn) < 0.05 mg/L

Hydrogen Sulde (H2S) 0.00 mg/L

< 170 mg/L (< 10 gpg)

Production Rate

1

Efciency Rate 8.67%

2

Recovery Rate 23.87 %

Daily Production Rate 11.19 gpd

Caution: Do not use with water that is microbiologically unsafe or of unknown quality without

adequate disinfection before or after the system. Systems certied for cyst reduction may be

used on disinfected water that may contain lterable cysts

(2)

Good Water Warehouse Inc.

Good Water Warehouse Reverse Osmosis System

GWW Inc.

1700 E Walnut Ave

Fullerton CA 92831

[phone]

[phone] FAX

NSF 58

Part Number: GOLDLINE-50

Systems Tested and Certied to NSF/ANSI 58

General installation / Operation / Maintenance Requirements

1. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Systems certied for cyst reduction may be used on disinfected water that may contain lterable cysts.

2. No iron present in feed water to R.O. System

4. Hardness of more than 7 grains may shorten membrane life

5. Manufacturer recommends a TDS test every six months

6. Efciency rating means the percentage of the inuent water to the system that is available to the user as reverse osmosis treated water
under operating conditions that approximate typical daily usage.

7. Recovery rating means the percentage of the inuent water to the membrane portion of the system that is available to the user as reverse
osmosis treated water when the system is operated without a storage tank or when the storage tank is by passed.

8. This system is acceptable for treatment of inuent concentrations of no more that 27 mg/L nitrate and 3 mg/L nitrite in combination
measured as N and is certied for nitrate/nitrite reduction only for water supplies with a pressure of 40 psi or greater.

9. The Goldine-50 installation should comply with all state and local laws and regulations.

10. This Reverse Osmosis System contains a replaceable treatment component critical for effective reduction of total dissolved solids. The
product water shall be tested periodically to verify that the system is performing satisfactorily.

11. See owners manual for manufacturer's limited warranty, installation, operation and maintenance requirements.

12. This system has been tested and shown to operate at its calculated recovery rating, or efciency rating, or both under standard test
conditions. Test parameters: 25º± 1ºC, 50 psi and pH of 7.5.

13. Chlorine in the inuent water may affect the RO membrane polymers.

This system has been tested according to NSF/ANSI 58 for reduction of substances listed below. The concentration of the indicated substances in water

entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specied in NSF/ANSI 58.

Testing was performed under standard laboratory conditions, actual performance may vary.

Ave.

Contaminant

* Barium 9.4 0.58 93.8 0.84

Cadmium 0.03 0.0004 98.7 0.0006

Chromium

(Hexavalent)

Chromium

(Trivalent)

Copper 3.0 0.033 98.9 0.066

Fluoride 8.6 0.4 95.6 0.5

Lead 0.15 0.002 98.7 0.003

Radium
226/228

Selenium 0.099 0.004 96.0 0.004

Turbidity 11 NTU 0.1 NTU 99.0 0.2 NTU

TDS 739 45 93.8 82

A performance indicator will monitor the performance of the RO membrane,

a critical component for the reduction of the above contaminants

Inuent

(mg/L)

0.29 0.026 91.2 0.033

0.32 0.017 94.8 0.022

25 pCi/L 5 pCi/L 80.0 5 pCi/L

Ave.

Efuent

(mg/L)

Ave. %

Reduction

US EPA

MCL

(mg/L)

Daily Production Rate 11.19 gpd

Recovery rate 23.87 %

Pressure Drop at Rated Flow 5 psi

System Weight 30 lbs

Efciency Rating 8.67 %

Min. / Max. Pressure 30/100 psi

Min. / Max. Temperature 4º/38ºc (40º/100º F)

Production Storage Capacity 2.4 gallons

Test parameters: 25º± 1ºC, 50 psi and pH of 7.5

Recommended Replacement of Membrane and Filters
R.O. Membrane 1204694 2 to 5 years
Sediment Prelter 1227867-V 6 months
Carbon Block Prelter 32-250-125-975 6 months
Carbon Block Prelter 32-250-125-975 6 months
Post Carbon Filter CL10ROT40-B 6 months

TDS, Barium, Cadmium, Hexavalent and Trivalent Chromium, Lead,

Radium 226/228, Selenium, Fluoride, Nitrite, Nitrate

Refer to owners manual for additional maintenance and warranty information

WQA certied for the reduction of:

(3)