Goodmans GSTV22 Owner's Manual

STEP 1

STEP 2

Model :

GSTV22P

SIDE METAL ARMSBASE WOODEN PANEL

Locate captive nuts (C) into the 4 holes in the underside of the bottom shelf ,
ensuring the threaded hole is correctly orientated to accept the threaded screw.

use 4 x screw and washer (C) to secure the legs to the bottom shelf , ensure
the screws are fully tightened using the supplied Hex key.
Fit the 4 rubber feet into the holes in the base of the legs

GLASS SUPPORT BARS TOP GLASS PANEL

STEP 3 STEP 4

loosely assemble the two glass support bars in place as shown using the
4 x Screw and washer (B) do not fully tighten at this stage, but just enough
to allow the glass to rest on the upright tubes

Before resting the glass on the upright tubes ensure the plastic tube end (A)
is fitted into all 4 upright tubes, gently rest the glass on the upright tubes and
using screw (A) and Chromed cap screw and plastic washer locate a screw
through each of the 4 upright tubes, do not fully tighten any of the screws until
all are fitted. Using both hex keys gently tighten them in a diagonal sequence,
do not overtighten.

FULLY ASSEMBLED

STEP 5

Final Checks Before positioning the stand in the final location ensure all assembly
screws are fully tightened and any protective coverings are removed. Always
remove a Plasma TV from this stand before attempting to move it.

PLASMA TV STAND ASSEMBLY INSTRUCTIONS

STAND PARTS

This stand is designed for use with Plasma and LCD type TV's only,

not suitable for use with traditional large screen CRT televisions.

FULLY ASSEMBLED

Model :

GSTV22P

SCREWS & WASHERS FOR

A

GLASS PANEL X 4

RUBBER FEET X 4

D

Goodmans technical

helpline 0870 8730080

FITTINGS

SCREWS & WASHERS FOR

B

GLASS SUPPORT BARS X 4

HEX KEY X 2

E

www.goodmans.co.uk

SCREWS, WASHERS & NUTS FOR

C

WOODEN PANEL X 4

Designed to the

exclusive specification of

Goodmans Industries Ltd

MU-GSTV22P-01