Goodmans GST104 Owner's Manual
GST104 Equipment Stand
A
2
Carton components
Step 1
Step 2
Screw Kit components
Important
Please read the cautionary notes at the end of this
instruction first.
Remove all contents from the carton and lay out
on a suitable flat surface.
Attach the short chrome legs (E) to the underside
(plain side) of the silver top (B) using 4 x screws
(F) and tighten using the Allen key provided (M)
Screw 4 x double ended studs (H) into the ends
of the legs (E) and then slide 4 x clear plastic end
caps (L) over the studs as shown in the enlarged
view (opposite)
Gently place the glass shelf (C) over the 4 x double ended
studs (H) with the frosted side facing up.
Slide 4 x clear plastic end caps (L) over the studs and then
screw 4 x long chrome legs (D) firmly onto the studs but
do not over tighten as this will put strain onto the
glass.
Attach the remaining 2 x long chrome legs (D) to the
underside (frosted side) of the glass shelf (C) by screwing
2 x plain studs (G) into 2 x chrome top caps (I) and finger
tighten.
Insert the studs through the two holes in the centre of the
glass shelf.
Slide 2 x clear plastic end caps (L) over the studs with the
collar facing upwards.
Next screw the 2 x long chrome legs (D) onto the studs
(G) ensuring that the clear plastic end cap (L) collar
inserts into the end of the leg (D).
Apply hand pressure to the chrome top cap (I) so that it
does not turn and tighten the leg (D) firmly but do not
over-tighten as this will put strain onto the glass
Take the base board (A) and position onto the ends of
the chrome legs as shown.
Using screws 6 x (F) screw the base board in place
firmly tightening all screws (F) with the Allen key
provided (M)
Step 3
Step 4
Completed Stand
Screw the 6 x glides (K) to the base board (A)
using the 6 x glide screws (J) and the predrilled blind holes on the base board (A)
Finally check that all fixings are tightened.
The stand is now complete. Gain assistance and
turn the stand over so that the glides are
resting on the floor.
Included in this carton are four double
sided sticky pads (N)
These should be stuck to the top board of
the stand in suitable positions before the
Television is placed on the top board.
This will assist in reducing any television
slide
IMPORTANT CAUTIONARY NOTES
IMPORTANT SAFETY PRECAUTION Always make sure that the
overhang of the top board (B) is to the rear of the stand.
Use only the fixings provided
Do not attempt to move the stand without supporting the electronic
equipment.
Do not use solvents to clean the stand, a soft contaminant free
damp cloth will suffice. If soiling is heavy a mild detergent may be
used.
Always gain assistance when moving heavy objects
“It’s your body, look after it”
In the unlikely event that any carton components are missing or
technical support on assembly of your stand is required, please call
our Customer care line on 01580 891521
SC601130 Rev 1
Loading...