Gomet Technology GWD910T, GWD910R User Manual

GWD 900

Wireless Microphone Owner’s Manual

GWD910 Waterproof Wireless Microphone System

GWD-910T & GWD-910R

Owner’s Manual

Taiwan Gomet Technology Co., Ltd.
No. 8-1, Lane 212, Sec. 1, Chang-Shang N. Rd,
Tamsui, Taipei Shien 25157, Taiwan
Tel: [phone]
Fax: [phone]
E-mail [e-mail]
Website www.gomet.com.tw

Wireless Microphone General Specification

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE CONDITION THAT THIS DEVICE DOES NOT CAUSE HARMFUL
INTERFERENCE. ( FCC ID :QS6-GWD910T & QS6-GWD910R )

Modulation Mode: Bi-Directional DSS (Digital Spread Spectrum)
Frequency: 902 ~ 925MHz
Handset RF Power Output
Base Station RF Power
Operating Range: 1000 ft.(300M)
Battery: 3.7V Rechargeable Li-Ion battery (Handset)
5V DC (Base Station)
Air Time: 9~10 hours of continuous operation
Standby Time: 4 days
Microphone: Internal microphone without lavalier
Channels: 8 Channels with Automatic Synchronization

• This GWD910 is protected against water splashes and dust.

• GWD910 Wireless Microphone will automatically turns ON and shut OFF when

recording is activated or deactivated through In-Car Video System.

• GWD910 Wireless Microphone is also able to trigger IN-CAR VIDEO SYSTEM to
activate digital video recording.

• Any GWD910 Wireless Microphone will work with any IN-CAR VIDEO SYSTEM
that is equipped with GWD910 receivers. - Automatic Synchronization

• Build-in Programmable Function Button, Panic Button & Mute Button

• LED indicators are used for status on mute, ON/OFF, signal, battery and panic

functions.

• GWD910 will automatically detect radio frequency noises, channel conflicts and cross
talks with as many as 20 units in close proximity, and perform auto switch to ensure
clear communication and recording.

21.69dBm / GWD-910T

Output 20.14dBm / GWD-910R

2

P

S

GWD 900 Wireless Microphone Owner’s Manual

GWD 900 Wireless Microphone Owner’s Manual

Hardware Overview

Wireless Microphone Wireless Microphone Receiver
GWD910T (-2400T) GWD910R (-2400R)

Charger, AC Wall Charger Cable & DC In-Car Charger Cable

System Overview

Wireless Microphone Receiver

1

SPM

1

Receiver’s Register Contact (CH1)

M

Green LED

The register contact is used to synchronize the frequency of the receiver and the
wireless microphone.

Green LED OFF for Microphone on Standby Mode
Green LED ON for Microphone on Recording Mode

Red LED
Red LED ON for Panic Mode ON

Red LED Blinking for Wireless Microphone Low Battery
Yellow LED

Red LED OFF for Panic Mode OFF

Yellow LED OFF for Strong Signal
Yellow LED ON for Signal is Marginal or Weak

3

4