Goldweb GD-W913N, GD-W913ND User Manual

GD-W913N/ND

1

1 Cable Connection

Please follow the steps below to connect the device

Step 1 Connect the ADSL port of the router to the Modem port of the splitter

using a telephone cable. Connect the phone to the phone port of the splitter

using a telephone cable. Connect the incoming line to the Line port of the

splitter.

Step 2 The spliiter has three ports:

LINE: Connect to a wall phone jack (RJ-11 jack)

Modem: Connect to the ADSL interface of the router

PHONE: Connect to a telephone set

Step 3 Connect the LAN port of the router to the network card of the PC through

an Ethernet cable.

Step 4 Plug one end of the power adapter into the wall outlet and the other end

to the Power port of the router.

The followig figure show the connection of the DSL router, PC and telephones.

Figure 1 Connecting the DSL router

GD-W913N/ND

2

2 WAN Configuration for Internet Connection

2.1 Configuring IP Address of Network Card

Configure TCP/IP properties of your network card to Obtain an IP address

automatically from modem, or set the IP address of the computer with the same

network mask of the modem.

For example, if the IP address of modem is 192.168.1.1/255.255.255.0, you can

set the IP address of the computer to 192.168.1.x/255.255.255.0. The range for x

is from 2 to 253.

2.2 Accessing Router

To log in to the DSL router, perform the followings:

Step 1 Open a Web browser on your computer.

Step 2 Enter http://192.168.1.1 (the default IP address of the DSL router) in the

address bar. The login page appears.

Step 3 Enter the user name and the password.

Step 4 Click OK to log in to the Web page. Otherwise, click Cancel to exit the

login page.

Figure 2 Login page

After logging in to the DSL router as a super user, you can query, configure, and

modify all the settings, and diagnose the system.

GD-W913N/ND

3

2.3 WAN Service

Choose Advance Setup > WAN Service, and the following page appears.

Figure 3 WAN service configuration

In this page, you may add, remove or edit a WAN service.

Adding a PPPoE WAN Service

This section describes the steps for adding the PPPoE WAN service.

Step1 In the Wide Area Network (WAN) Service Setup page, click the Add

button to display the following page. (First a proper ATM configuration

should be added for this WAN service.)

Figure 4 WAN service interface configuration (PPPoE)

GD-W913N/ND

4

Step2 In this page, you can select a ATM Interface for the WAN service. After

selecting the ATM interface, click Next to display the following page.

Figure 5 WAN service configuration (PPPoE)

Step3 In this page, select the WAN service type to be PPP over Ethernet

(PPPoE). Click Next to display the following page.