Gold Medal Products 2035DC User Manual

© 2017 Gold Medal Products Co.
Part No. 74570
10700 Medallion Drive, Cincinnati, Ohio 45241-4807 USA
Mighty-Mite
Model No. 2035BG, 2035EX, 2035DC
gmpopcorn.com
DANGER
Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Any alterations to this equipment will void the warranty and may cause a dangerous condition. This appliance is not intended to be operated by means of an external timer or separate remote-control system. NEVER make alterations to this equipment. Read the Installation, Operating, and Maintenance Instructions thoroughly before installing, servicing, or operating this equipment.
014_020416
WARNING
DO NOT store or use gasoline, or other flammable vapors and liquids, in the vicinity of this equipment.
004_010914
WARNING
Instructions on what to do when a user smells gas can be obtained from the local gas supplier. These instructions must be posted in a prominent location where the unit is to be operated.
005_010914
WARNING
To avoid burns, DO NOT touch the kettle or any heated surface. DO NOT place or leave objects in contact with heated surfaces.
013_092414
WARNING
ALWAYS wear safety glasses when servicing this equipment.
010_010914
WARNING
No user serviceable parts inside. Refer servicing to qualified service personnel.
011_051514
WARNING
Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862
022_060215
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
SAFETY PRECAUTIONS (continued)
Page 2
gmpopcorn.com
WARNING
DO NOT allow direct contact of this equipment by the public when used in food service locations. Only personnel trained and experienced in the equipment operation may operate this equipment. Carefully read all instructions before operation.
012_010914
WARNING
This machine is NOT to be operated by minors.
007_010914
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
SAFETY PRECAUTIONS (continued)
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Note: Improvements are always being made to Gold Medal’s equipment. This information
may not be the latest available for your purposes. It is critical that you call Gold Medal’s Technical Service Department at 1-800-543-0862 for any questions about your machine operations, replacement parts, or any service questions. (Gold Medal Products Co. does not assume any liability for injury due to careless handling and/or reckless operation of this equipment.) General images may be used in manual for reference only.
Page 3
gmpopcorn.com
Aluminum Scoop
Tank Regulator
Tank Hose
20 cc Measure
6 oz. Measure
16 oz. Corn Measure w/Handle
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be filed immediately with the transportation company. The warranty does not cover damage that occurs in transit, or damage caused by abuse, or consequential damage due to the operation of this machine, since it is beyond our control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold
Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.
Model Description
2035BG: 16 oz. Mighty-Mite Popper, LP Gas, utilizes an electric kettle drive motor.
2035EX: Export, 16 oz. Mighty-Mite Popper, LP Gas, utilizes an electric kettle drive motor.
2035DC: 16 oz. Mighty-Mite Popper, LP Gas, utilizes a DC powered kettle drive motor
(battery is not included with this unit).
Items Included with this Unit
Page 4
gmpopcorn.com
Counterweight Assembly
1/4-20 Hex Head bolt
Counterweight
Knob
Set Screw
Counterweight Bar
Kettle
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Setup
This unit has been tested at the factory.
1. Remove all packaging and tape prior to operation.
2. This unit is for outdoor use only.
3. Place popper on a level, sufficiently stable base or counter that is strong enough to
safely support it when in use. This unit is certified for use on combustible surfaces.
4. Observe the following clearances to ensure proper air supply and maintenance:
Minimum of 6 inches clearance on each side of unit.
Minimum of 30 inches clearance for the front, back, and top of unit.
5. Bolt the popper to the counter to secure it from tipping.
6. Attach the counterweight assembly per illustration below.
7. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of
this manual).
Page 5
gmpopcorn.com
DANGER
Gas is safe when used properly, but can be very dangerous when used improperly. We suggest that installation be carefully made by qualified personnel only. Gas companies have competent service personnel to provide safe installation.
001_010914
CAUTION
Be sure to observe all clearances for this unit. Refer to the Setup Section of this manual to ensure proper air supply and adequate clearance for servicing and installation of this gas unit.
033_042814
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Gas Installation Instructions
DO NOT connect the unit to a power source before gas connection is complete.
Gas Requirements
The 2035BG, 2035EX, and 2035DC are designed for Propane only. Converting the unit to an alternate fuel source will void the warranty and may cause a dangerous condition.
2035BG, 2035EX, and 2035DC: Propane Gas, 12,600 BTU/HR
NOTE: The unit must be attached to a minimum of 40 pound LPG cylinder. For outdoor
use only.
Gas Installation
When installing this gas unit in the United States, you must conform with local codes, or in the absence of local codes, with National Fuel Gas Code, ANSI Z223.1 (latest edition).
NOTE: Some local codes may require ventilation hoods or automatic fire systems. During
any pressure testing of the gas supply piping system at pressure equal to or less than 1/2 psig (3.45 kPa), the appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve.
After installation, all gas connections must be checked for leaks with a soap
solution (see Checking for Gas Leaks section of this manual).
Page 6
gmpopcorn.com
DANGER
Hot oil is dangerous – severe burns can result when hot oil contacts the skin. Hot oil is flammable – keep open flames away from hot oil and its vapors. Keep a fire extinguisher near this unit. Instruct personnel on what to do if there is a grease fire. DO NOT USE WATER ON A GREASE FIRE! Use only fire extinguishers approved for grease, oil, and electric fire.
002_102214
DANGER
DO NOT use a match or flame to check for gas leaks – you may cause a fire or explosion! When gas connections are complete, have a qualified professional wire the unit to a power source which will carry the current specified on the unit’s data plate.
034_042814
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Important Fire Safety Notice
Consult your local fire protection agency for your area’s requirements. Check local fire protection
requirements regularly to ensure compliance with local codes and proper operation. Have a fire extinguisher near the unit. (Use only fire extinguishers approved for grease, oil, and electrical fires.)
Checking For Gas Leaks
After making any gas connection, or after performing any work on the gas train, ALWAYS check ALL gas connections for leaks with a soap solution.
1. Apply SOAP BUBBLES to all connections and pressurize the gas line to check for leaks.
Perform this test outdoors away from any flames or sparks. DO NOT use a flame to check for gas leaks.
2. It is recommended to check your flexible gas lines and gas fittings for wear and tear on
a frequent basis. Stop using the appliance immediately if damage is found, and contact a qualified professional to inspect and correct any issue.
3. Securely route all gas lines away from flames and high temperature areas.
4. Contact Gold Medal Technical Support, or a qualified Gas Service Technician with any
questions.
Gas Pressure
We have determined that optimum popping occurs when the gas pressure is adequate. For propane gas, we recommend a manifold pressure setting of 10 inches of water column. The pressure is measured at the appliance when the main burner is ignited.
Lighting and Shutdown Instructions
When gas installation is complete, the unit must be connected to a power source prior to lighting the unit (reference the Electrical Installation Instruction section). For pilot and burner lighting and shutdown instructions, refer to the Operating Instruction section of this manual.
Page 7
gmpopcorn.com
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Page 8
gmpopcorn.com
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Page 9
gmpopcorn.com
Mighty-Mite Model No. 2035BG, 2035EX, 2035DC
Page 10
Loading...
+ 22 hidden pages