Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment
will void the warranty and may cause a dangerous condition. This appliance
is not intended to be operated by means of an external timer or separate
remote-control system. NEVER make alterations to this equipment. Read the
Installation, Operating, and Maintenance Instructions thoroughly before
installing, servicing, or operating this equipment.
008_051514
014_020416
This machinery contains sharp blades. Keep hands and body parts clear
at all times.
NEVER put your fingers into the shaver body (the goose-neck, ice chute, or
hopper). Serious injury may occur.
ALWAYS wear safety glasses when servicing this equipment.
No user serviceable parts inside. Refer servicing to qualified service
personnel.
037_103114
017_103114
010_010914
011_051514
http://www.gmpopcorn.com Page 2
Sno-King Model No. 1888, 1888EX
WARNING
WARNING
WARNING
Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive,
Cincinnati, OH 45241 USA 1-(800)-543-0862
DO NOT allow direct contact of this equipment by the public when used in
food service locations. Only personnel trained and experienced in the
equipment operation may operate this equipment.
Carefully read all instructions before operation.
This machine is NOT to be operated by minors.
022_060215
012_010914
007_010914
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Note: Improvements are always being made to Gold Medal’s equipment. This information
may not be the latest available for your purposes. It is critical that you call Gold Medal’s
Technical Service Department at 1-800-543-0862 for any questions about your
machine operations, replacement parts, or any service questions. (Gold Medal
Products Co. does not assume any liability for injury due to careless handling and/or
reckless operation of this equipment.) General images may be used in manual for
reference only.
http://www.gmpopcorn.com Page 3
Sno-King Model No. 1888, 1888EX
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be
filed immediately with the transportation company. The warranty does not cover damage that occurs in
transit, or damage caused by abuse, or consequential damage due to the operation of this machine, since
it is beyond our control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this equipment.
To order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co.,
10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.
Setup
Your new Sno-King is completely assembled and tested at the factory.
1. Remove all packing material and tape before starting operation.
2. Place unit on a sturdy, level base which can withstand accidental dripping of water and ice.
3. Connect the drain hose (provided with unit) to funnel excess water to floor drain or basin tub.
Drained water is not intended for human consumption.
4. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of this
manual).
http://www.gmpopcorn.com Page 4
Sno-King Model No. 1888, 1888EX
DANGER
CAUTION
Electrical Requirements
The following power supply must be provided (reference unit Data Plate):
1888: 120 V~, 60 Hz
1888EX: 220-230 V~, 50/60 Hz
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
A certified electrician must furnish sufficient power for proper machine operation and install any
supplied receptacle. We recommend this equipment be on a dedicated and protected circuit. Failure to
wire properly will void the warranty and may result in damage to the machine. It is Gold Medal Products
Co.’s recommendation that this machine be plugged directly into a wall outlet. The use of extension cords
is not recommended due to safety concerns, and may cause sacrificed and/or reduced performance. Make
sure cord is located to prevent a trip hazard or unit upset.
008_051514
Before You Plug In Machine
1. Make sure all machine switches are in the OFF position before plugging the equipment into the
receptacle.
2. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power
supply cord.
3. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect
the outlet and correct if necessary.
4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).
5. Install the unit in a level position.
If the supply cord is damaged, it must be replaced by Gold Medal Products Co.,
its service agent or similarly qualified persons in order to avoid a hazard.
039_080614
http://www.gmpopcorn.com Page 5
Sno-King Model No. 1888, 1888EX
GENERAL INSTRUCTIONS
Ice Requirements
The shaver can take ice cubes or block ice, if you break the block into pieces approximately 2 to
3 inches in size. The ice will not enter the shaving chute if the pieces are too large.
NOTE: Harder ice will result in a finer snow; soft ice will result in a coarser snow.
To Operate the Shaver
1. Raise Hopper Lid (pusher cap) and load hopper with ice.
2. Close pusher cap, and apply gentle downward pressure.
3. Turn on the power switch.
4. Press and hold in the momentary switch. Release the button once all of the ice has been shaved.
5. Do not lift the pusher cap until the motor is off and the shaver head has stopped.
NOTE: Never allow any foreign or metallic objects around the shaver area. Ice picks, scoops,
and debris that may be in the ice often damage blades.
http://www.gmpopcorn.com Page 6
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.