Gold Medal Products 1027 Operators Manual

Part No.12205

Hawaii’s Finest

Instruction Manual

Model No. 1027

10700 Medallion Drive, Cincinnati, Ohio 45241-4807 USA

cause property damage, injury, or death. Any alterations to this equipment will

Hawaii’s Finest Model No. 1027

SAFETY PRECAUTIONS

DANGER

Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.

DANGER

Improper installation, adjustment, alteration, service, or maintenance can

void the warranty and may cause a dangerous condition. NEVER make
alterations to this equipment. Read the Installation, Operating, and
Maintenance Instructions thoroughly before installing, servicing, or operating
this equipment.

008_051514

014_051514

WARNING

This machinery contains sharp blades. Keep hands and body parts clear
at all times.

037_103114

WARNING

NEVER put your fingers into the shaver body (the goose-neck, ice chute, or
hopper). Serious injury may occur.

017_103114

WARNING

ALWAYS wear safety glasses when servicing this equipment.

010_010914

WARNING

No user serviceable parts inside. Refer servicing to qualified service
personnel.

011_051514

Page 2

gmpopcorn.com

Hawaii’s Finest Model No. 1027

SAFETY PRECAUTIONS (continued)

WARNING

Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive,
Cincinnati, OH 45241 USA 1-(800)-543-0862

WARNING

DO NOT allow direct contact of this equipment by the public when used in
food service locations. Only personnel trained and experienced in the
equipment operation may operate this equipment.
Carefully read all instructions before operation.

WARNING

022_010914

012_010914

This machine is NOT to be operated by minors.

Note: Improvements are always being made to Gold Medal’s equipment. This

information may not be the latest available for your purposes. It is critical that
you call Gold Medal’s Technical Service Department at 1-800-543-0862 for any
questions about your machine operations, replacement parts, or any service
questions. (Gold Medal Products Co. does not assume any liability for injury due
to careless handling and/or reckless operation of this equipment.)

007_010914

Page 3

gmpopcorn.com

Hawaii’s Finest Model No. 1027

General Operating Safety

when using a Foot Switch

WARNING

Always use a grounded plug or cable. DO NOT cut off the ground prong and
be sure to ground the foot switch with the ground screw provided.

CAUTION

Failure to use foot switch safely could result in personal injury. Foot switch
should only be used where adequate guards or other safety devices are in
place for those applications where the use of a foot switch could cause
personal injury.

• Follow the appropriate wiring and safety requirements as set forth in the American

National Standards Institute (ANSI) and National Electrical Code (NEC) or other
appropriate standards.

• Use proper electrical circuits and circuit protection when wiring foot switch.

• Disconnect power before servicing.

• Do not allow cord to rest on floor or in areas where it can be a tripping hazard or can be

abused by heavy traffic.

• Do not leave foot switch accessible to inadvertent operation when left unattended or

when not being used.

• Do not bypass any machine or equipment safety features with this foot switch.

• Replace damaged cord immediately.

• It is the responsibility of the user to determine the suitability of a foot control for the

intended use.

• It is the responsibility of the user to comply with federal, state and local safety and health

regulations.

Page 4

gmpopcorn.com

Hawaii’s Finest Model No. 1027

INSTALLATION INSTRUCTIONS

Inspection of Shipment

After unpacking, check thoroughly for any damage which may have occurred in transit. Claims
should be filed immediately with the transportation company. The warranty does not cover
damage that occurs in transit, or damage caused by abuse, or consequential damage due to the
operation of this machine, since it is beyond our control (reference warranty in back of manual).

Manual

Read and understand the operator’s manual and all other safety instructions before using this
equipment. To order copies of the operator’s manual go to gmpopcorn.com or write to Gold
Medal Products Co., 10700 Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.

Items Included with this Unit

Drain Hose

Optional Accessory: Foot Switch (sold separately, Item No. 1008)

Setup

This unit has been tested at the factory.

1. Remove all packaging and tape prior to operation.

2. Place unit on a sturdy, level base which can withstand accidental dripping of water

and ice.

3. Connect the drain hose to funnel excess water to floor drain or basin tub. Drained

water is not intended for human consumption.

4. After setup, the unit should be cleaned prior to use (see Care and Cleaning section of

this manual).

Page 5

gmpopcorn.com

Hawaii’s Finest Model No. 1027

Electrical Requirements

The following power supply must be provided:

1027: 120 V~, 840 W, 60 Hz

DANGER

Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.

A certified electrician must furnish sufficient power for proper machine operation and install any
supplied receptacle. We recommend this equipment be on a dedicated and protected circuit.
Failure to wire properly will void the warranty and may result in damage to the machine. It is Gold
Medal Products Co.’s recommendation that this machine be plugged directly into a wall outlet. The
use of extension cords is not recommended due to safety concerns, and may cause sacrificed
and/or reduced performance. Make sure cord is located to prevent a trip hazard or unit upset.

008_051514

Before You Plug In Machine

1. Make sure all machine switches are in the OFF position before plugging the equipment

into the receptacle.

2. Make sure the wall outlet can accept the grounded plugs (where applicable) on the

power supply cord.

3. The wall outlet must have the proper polarity. If in doubt, have a competent

electrician inspect the outlet and correct if necessary.

4. DO NOT use a grounded to un-grounded receptacle adapter (where applicable).

5. Install the unit in a level position.

If the supply cord is damaged, it must be replaced by a special cord or
assembly available from Gold Medal Products Co. or its service agent.

CAUTION

038_062714

Page 6

gmpopcorn.com