Gold Medal Products 1020T Service Manual

Shavatron

Instruction Manual

Model # Domestic: 1020, 1020T

Export: 1020EX, 1020TEX

Part No. 39099

Cincinnati, OH 45241-4807 USA

SAFETY PRECAUTIONS

Installation Instructions

Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during transit. Damage

claims should be filed immediately with the transportation company. Gold Medal is not responsible for
damage that occurs in transit.

Setup:

Your new Shavatron Ice Shaver Machine is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.

Electrical Requirements:

The following power supply must be provided:

Model No. 1020, 1020T: 120 Volts, 970 Watts, 60 Hz.
Model No. 1020EX, 1020TEX: 230 Volts, 820 Watts, 50Hz.

.

Your electrician must furnish sufficient current for proper machine operation. We recommend this ice shaver
machine be on a dedicated and circuit protected line. Failure to wire properly will void the warranty and can
result in damage to the light, motor and etc.

It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a wall outlet.
The use of extension cords is not recommended due to safety risks and the ice shaver’s performance will be
sacrificed/reduced.

Before You Plug In Machine:

1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power supply cord.

2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the outlet
and correct if necessary.

3. DO NOT use a three (3) prong grounded to two (2) prong un-grounded adapter.

4. If the optional 1078HD Chute is attached to your machine, follow the installation instructions provided
with the 1078HD Chute before operation.

Shavatron

Ice Shaver

Operating Instructions

Make sure the hopper is clear of obstructions, then secure a supply of ice (either blocks, cubes or
rough crushed ice) and fill the hopper. Ice chunks should be no larger than a baseball for maximum
capacity (large ice chunks take more time to shave).

1. Move the toggle power switch into the “ON” position to illuminate the lights.

2. Fill the hopper with ice. Be careful not to overfill.

3. Close the hopper lid. The unit will not operate if the lid is not completely closed.

4. Push the momentary motor switch.

Metal or foreign objects will ruin the shaving blades instantly.
Make sure that both the hopper and ice supply are free of debris
including: Ice picks, scoops, nails, nuts, bolts, etc.

Safety Cut-Off Switch

CAUTION

on, the machine will not operate with the hopper lid open. This is to prevent accidental injury while
loading or cleaning the hopper. Be careful not to overfill the hopper to the extent that the hopper lid
stays open. The lid must be closed and you must press the momentary motor switch in order for the
machine to operate.

Your Shavatron is equipped with a safety cut-off switch. With the momentary motor switch pressed

Never put your fingers or any object into the shaver body while the unit
is running. Since you can be seriously hurt by not following these
instructions, Gold Medal does not assume any liability for injury due to
careless handling or operation of this unit.

Shavatron

Ice Shaver

MAINTENANCE INSTRUCTIONS