Gold Medal Econo-Floss, Mega-Floss Instruction Manual

Econo-Floss / Mega-Floss

Instruction Manual

SAFETY PRECAUTIONS

!

▲ CAUTION

This equipment is designed and sold for commercial use only. This
equipment is not to be used by the consumer in home use. Do not allow
direct contact of this equipment by the public when used in food service
locations. Only personnel trained and experienced in the equipment
operation may operate this equipment.
Carefully read all installation instructions before operating the equipment.

!

▲ WARNING

Always wear safety glasses when servicing this equipment.

!

▲ WARNING

To avoid serious burns, do NOT touch the kettle while it is hot.

!

▲ WARNING

Any alterations to this equipment will void the warranty and
may cause a dangerous situation. NEVER make alterations
to the equipment.
Make sure all machine switches are in the OFF position
before plugging the equipment into a receptacle.

!

▲ DANGER

Machine must be properly grounded to prevent electrical shock
to personnel.
Do NOT immerse the kettle, warmer, or any other part of this
equipment in water.
Always unplug the equipment before cleaning or servicing.

NOTE

The information, specifications and illustrations contained in this manual represent
the latest data available at time of publication. Right is reserved to make changes as
required at the discretion of Gold Medal Products Company without notice.

2

CHECKING UNIT

Check thoroughly for any damage which may have occured in transit. NOTE: Before

plugging in the cotton candy machine, the shipping bracket must be lowered.

This can be done easily by turning the two knobs on each side of the cabinet top then
pushing the knobs down to assure that the bracket is completely lowered. This will
allow the bell housing to float freely on the springs.

LOCATION

Place the ECONO-FLOSS / MEGA-FLOSS MACHINE onto the cart or table. Ventila
tion around the machine is important to insure proper operation. Be sure to allow a
minimum of six inches around each side vent. Do not remove the rubber feet.

Wash the floss pan thoroughly with soap and water. Install Floss Stabilizer on floss
pan (See diagram, page 7). Then put pan on the machine with the floss head extend
ing up through the center of the pan.

As a last precaution before plugging in the machine, look inside the
head assembly and make sure the floss ribbon (heating element)
has not shaken out of the band during transportation. If the ribbon
is out of the band, push it back into place with the index finger.

INST ALLATION INSTRUCTIONS

!

▲DANGER

ELECTRICAL REQUIREMENTS

The GOLD MEDAL ECONO-FLOSS / MEGA-FLOSS MACHINE is
ready to plug into a 15 amp, 120 volt, 60 cycle standard wall recep

tacle. Maximum amp draw for the unit at 120 volts is 9 amperes.

NOTE: This figure is an approximation and may vary slightly. An

overloaded electric circuit will not allow the ECONO-FLOSS /
MEGA-FLOSS to make cotton candy.

FLOA TER ADJUSTMENT

Form leather floaters as shown.
This creates a lifting action to
float the floss across the gap to
the side of the floss pan.

You must have
the floss
machine
grounded! No
exceptions!!!

ROTATION

Leather
Floater

3