Gold Medal Karmel King 2620, Karmel King 2621, Karmel King 2630, Karmel King 2631 Instruction Manual

Part No. 18736

Revised: February 2009

KARMEL KING

Instruction Manual

Models: 2620 & 2621 (240 Volt)

2630 & 2631 (208 Volt)

SAFETY PRECAUTIONS

___________________________________ KARMEL KING

Mark 10, Karmel King (20 Gallon), and 2622 Rolling Truck

Left Hand Mark 10 (2411E) or Karmel King (2621) on 2622 truck shown

Electrical Specifications:

 Mark 10 (2410E - RH, 2411E - LH) - 120/208v or 120/230v 4 wire (2 hot, 1 neutral, 1 ground) 60

Hz.
5520 watts 30 amp plug & receptacle ( NEMA L14-30P & L14-30R )

 Karmel King/Models: 2620 RH, 2621 LH – 240v (2 hot, 1 ground) 50/60Hz.
7100 watts 50 amp plug & receptacle 50 amp plug ( NEMA 6-50P & 6-50R )
 Karmel King/ Models: 2630 RH, 2631 LH – 208v (2 hot, 1 ground) 50/60Hz.

6760 watts 50 amp plug & receptacle 50 amp plug ( NEMA 6-50P & 6-50R )

Other Dimensions:

 As shown.
 40´x 60” Cooling Pan should be located approximately 3-5” below the Corn Treat Mixer Base

Model 2622 (Rolling Table)

 Includes Casters
 Includes (1) cooling pan ( order p/n 48845 for extra cooling pan)

e-mail: www.gmpopcorn.com

Gold Medal Products Co.

10700 Medallion Drive

Cincinnati, Ohio 45241-4807

Phone: [phone] fax: [phone]

9/05

MODEL # 2620,2621,2630, AND 2631 3

___________________________________ KARMEL KING

INSTALLATION

CHECKING SHIPMENT

Unpack the shipping crate and check thoroughly for any damage which may have occurred in
transit. Any claims should be filed immediately with the transportation company.

ELECTRICAL REQUIREMENTS

Voltage for the 2620 AND 2621 is 240 volt, 3-WIRE ( 2 HOT, 1 GROUND) 60 cycle single phase. A wall
receptacle is supplied with the machine. This receptacle will accept the attachment plug on your machine
and must be used. The machine will draw a maximum of 30amps. Your electrician must finish sufficient
current for the proper operation of your machine. We recommend that this machine be fused on a line by
itself.

Voltage for the 2630 AND 2631 is 208 volt, 3-WIRE ( 2 HOT, 1 GROUND) 60 cycle single phase. A wall
receptacle is supplied with the machine. This receptacle will accept the attachment plug on your machine
and must be used. The machine will draw a maximum of 30amps. Your electrician must finish sufficient
current for the proper operation of your machine. We recommend that this machine be fused on a line by
itself.

COUNTER MOUNTING REQUIREMENTS/INSTRUCTIONS

MODEL # 2620,2621,2630, AND 2631 4