Gold Medal Hawaii's Finest 1047 Instruction Manual

Hawaii's Finest

Ice Shaver Instruction Manual

Model #1047

Part No. 12279

Cincinnati, OH 45241-4807 USA

Hawaii's Finest Ice Shaver

2

SAFETY PRECAUTIONS

All Models #1047

Hawaii's Finest Ice Shaver

3

SPECIAL FEATURES

1. Model 1047 uses cubed ice.

2. Snow texture can be adjusted easily with adjustment knob.

3. Blade is easily removable for replacement.

4. Safety switch is installed in loading lid, preventing motor from operating while lid is open.

5. Thermal protected motor, with remotely mounted reset button.

SPECIFICATIONS

Dimensions: 31” high (lid open) x 18" wide x 21" deep.
Net weight: 80 pounds.
Motor: 120 Volts, 12.8 Amps max., 60Hz.
Accessories: Foot switch.

INSTALLATION

1. Be sure to connect electrical plug to a grounded receptacle only.

2. Leave enough room in the back of machine to allow hookup of drain hose. Dump unused ice
and water from drain hose to floor drain or basin tub. Drain water from hose is not intended for
human consumption!

3. Be sure unit is on table that is sturdy and can withstand accidental dripping of water and ice.

USING YOUR MACHINE

1. Allow ice to soften at least (1) hour in a ice cooler before use, using ice straight from the freezer
effects the quality of the shaved ice as well as it could damage the shaver blade.

2. Lift cover lid and load ice cubes to 1/2" of top, close lid. Be sure ice is loaded evenly in each
cavity. Place cup directly below ice chute and turn power “ON”. NOTE: Failure to close lid will
cause machine not to operate!

3. Adjust blade height with adjustment knob to achieve the preferred ice texture.

4. To stop, turn power switch to “OFF” position. NOTE: Should the motor thermal protector trip
(the motor stops despite machine being plugged in and the power switch in the “ON” position),
reset by pushing the red button. It is recommended the cause of over load be found and
eliminated before continuing. The machine may need to cool a bit before the reset button may
take effect.

All Models #1047

Hawaii's Finest Ice Shaver

4

CLEANING INSTRUCTIONS

1. Remove lid by removing the wingnut and hinge pin.

2. Remove four plastic button screws that hold top hopper cover, and lift and roll over.
Disconnect wire harness at plug.

NOTE: When reinstalling cover, you MUST reconnect plug!

3. Remove three thumb screws and remove impeller cover.

4. Remove impeller knob, and lift impeller off. For removal of Impeller Knob a
screwdriver slot is supplied on bottom end of motor.

5. Lift off bottom plastic base cover.

6. Remove two stainless steel button screws holding chute.

7. Wipe down all easily accessible areas with a clean, dry cloth. (Do not use cleaners
that are ammonia based).

TO REMOVE BLADE AND BLADE HOLDER

1. Blade holder should be cleaned at weekly intervals. Begin removal by removing
chute.

2. Using blade adjustment knob, unscrew blade adjustment shaft and remove.

3. Pull pivot pin out completely.

4. Blade, blade holder assembly and spring are now free for removal.

5. Remove three readily removable blade retainers and remove blade.

6. Wipe area and parts with clean, dry cloth.

7. Assemble in opposite order as above.

All Models #1047