Gold Medal Astro Pop 2004, Astro Pop 2004SL Instruction Manual

AstroPop Warmer

a

Instruction Manual

Models #2004 and #2004SL

Part No. 40269

Revised August 2000

Cincinnati, OH 45241-4807 USA

e-mail: [e-mail] www.gmpopcorn.com

SAFETY PRECAUTIONS

a

Astro-Pop Warmer

a

INTRODUCTION

Your new #2004 Astro-Pop Warmer is shipped completely assembled, ready to operate. After remov­ing the corrugated carton from the machine, check thoroughly for any damage which may have
occurred in transit. Claims should be filed immediately with the transportation company.

Remove all cardboard packing and tape from the machine. Wipe all exposed surfaces with a damp
cloth to remove fingerprints, smears, etc. which may have occurred during unpacking and handling.

ELECTRICAL REQUIREMENTS

Standard voltage for the Astro-Pop Warmer is 120V, 60 cycle, single phase, A.C. current. The unit
should be placed on its own 20 Amp (4 wire) electrical circuit. The switches to control the heater and
lights are located at the top on the inside of the cabinet.

CARE AND CLEANING

The aluminum frame of the Warmer is easy to keep clean. Usually a damp cloth will remove all dirt
and grease spots. NEVER USE ABRASIVES on the aluminum framework. The glass should always
be clean and sparkling. Remember the inside of the glass must be cleaned too. The vertical air ducts,
mounted on the inside of the cabinet, disassemble without tools for easy cleaning. Periodically, empty
out all the popcorn and remove the shelves and clean the inside of the machine. A damp cloth will
usually pick up all the scraps of popcorn that has been spilled. Empty the old maid drawers and wipe
clean. Remove the bottom cabinet pans and clean out any stray debris.

1

MODEL #2004

Astro-Pop Warmer

a

MAINTENANCE INSTRUCTIONS

THE FOLLOWING SECTIONS OF THIS MANUAL ARE IN­TENDED ONLY FOR QUALIFIED SERVICE PERSONNEL WHO
ARE FAMILIAR WITH ELECTRICAL EQUIPMENT. THESE ARE
NOT INTENDED FOR THE OPERATOR.

Adequate eye protection must be used when servicing this
equipment to prevent the possibility of injury.

Do NOT immerse the kettle, warmer, or any other part of this
equipment in water.
Unplug your machine before servicing.

ORDERING SPARE PARTS

1. Identify the needed part by checking it against the photos, illustrations, and/or the parts list.

2. When ordering, please include part number, part name, and quantity needed.

3. Please include your model name and machine serial number (located on the machine
nameplate) with your order.

4. Address all parts orders to:

Parts Department

Gold Medal Products Co.

10700 Medallion Drive

Cincinnati, Ohio 45241-4807

or, place orders at:

[phone]

Fax: [phone]

E-mail: [e-mail]

or Web Page

www.gmpopcorn.com

See our complete catalog for

more Gold Medal Funfood

Equipment and Supplies

2

MODEL #2004

CABINET ASSEMBLY

a

Astro-Pop Warmer

3

MODEL #2004

PARTS LIST - CABINET ASSEMBLY

a

Model #2004 Model #2004SL

Item No. Part No. Part No. Description

1 40130 40130 Shelf, Adjustable
2 40143 40143 Shelf Support
3 40142 40142 Shelf Support
4 40145 40145 Blower Bracket
5 40148 40148 Motor Mount Plate
6 40153 40153 Nozzle Heater
7 41282 41282 Rubber Foot
8 40292 40282 Duct Panel
9 40177 40177 Duct Bracket
10 40293 40284 Duct Cover
11 76097 76097 Label, "Unplug to Clean"
12 40184 40184 Intake Cover
13 40185 40185 Exhaust Box
14 n/a n/a
15 40352 n/a Door
16 40193 40193 Bottom Frame Assembly
17 41870 41870 Corner Post, Front
18 40255 40255 Thermostat
19 40270 40270 Thermostat Mount
20 40192 41870 Corner Post
21 40272 40272 Switch Label
22 40297 40297 Corn Pan, L.H.
23 40296 40296 Corn Pan, R.H.
24 40276 40276 Old Maid Pan
25 41013 41013 Knob, Door
26 41016 41016 Single Pole Switch
27 41033 41033 Pilot Light
28 41106 41106 Switch Box
29 41349 n/a Male Hinge, Right
30 41350 n/a Male Hinge, Left
31 41351 n/a Female Hinge, Right
32 41352 n/a Female Hinge, Left
33 41452 41452 Warning, 75W Max
34 41456 41456 Strain Relief
35 41635PMO 40267 Glass, Front
36 41636PMO 47421 Glass, Side
37 41643 41643 Light Mount Bracket
38 n/a n/a
39 41671 41671 Floodlight, 75W
40 41703 41703 Magnet Catch Bracket
41 41712 41712 Molded Receptacle
42 41765 40263 Glass Retainer, Front
43 41766 40264 Glass Retainer, Rear
44 41858 41858 Rigid Channel, 32"

Astro-Pop Warmer

4

MODEL #2004

PARTS LIST - CABINET ASSEMBLY (continued)

a

Model #2004 Model #2004SL

Item No. Part No. Part No. Description

45 41946 40169 Top Frame Assembly
46 41956 41956 Light Shield
47 n/a n/a
48 47047 47047 Lamp Holder
49 n/a n/a
50 n/a n/a
51 47282 47282 Bushing, Snap #UB-65
52 47561 47561 Magnetic Catch
53 47580 47580 Lead-In Cord
54 47604 47604 Strain Relief, #SR8P-2
55 47695 47695 Rigid Channel, 23"
56 47701 47701 Acorn Nut, #6-32
57 47702 47702 Acorn Nut, #8-32
58 47771 47771 Screw, #8-32 x
59 47772 47772 Screw, #6-32 x 3/8" Flat
60 47799 47799 Light Shield Angle
61 40254 40254 Blower, 50/60 Hz
62 74087 74087 Double Pole Switch
63 74131 74131 Ring Terminal, #10
64 74146 74146 Hex Nut, #8-32
65 74149 74149 Hex Nut, #8-32
66 74150 74150 Washer, #8 Internal Tooth
67 47237 47237 Magnet Strike
68 41526 41526 Dome Spacer

3

/8" Hex

Astro-Pop Warmer

5

MODEL #2004

PARTS NOT SHOWN  S/S DOME

a

Model #2004

Item No. Part No. Description

1 40198 Complete Dome Assembly
2 40278 Main Wrapper
3 41020 Light Tube Holder
4 41021 Holder with Starter
5 41503 Support Angle
6 41504 Lamp Reflector
7 41506 Popcorn Sign
8 41507 Fluorescent Tube
9 41508 Fluorescent Starter
10 41509 Light Ballast
11 47726 Molded Plug

Astro-Pop Warmer

PARTS NOT SHOWN  SLIDING DOORS

Model #2004SL

Item No. Part No. Description

12 40289 Left Door Assembly
13 40287 Door Drilling, L.H.
14 40290 Right Door Assembly
15 40288 Door Drilling, R.H.
16 40166 Nylon Bushing
17 40176 Roller
18 40285 Door Stop
19 40286 Door Handle
20 42227 Screw, #8-32 x 3/8"
21 40195 Screw, #6-32 x ¾"
22 40273 Top Guide
23 40170 Bottom Track

6

MODEL #2004

WIRING DIAGRAM  2004, 2004SL

a

Astro-Pop Warmer

7

MODEL #2004

WARRANTY

WE WARRANT to the original purchaser the Gold Medal equipment sold by us to
be free from defects in material or workmanship under normal use and service. Our
obligation under this warranty shall be limited to the repair or replacement of any
defective part for a period of six (6) months from the date of sale to the Original
Purchaser with regard to labor and two (2) years with regard to parts and does not
cover damage to the equipment caused by accident, alteration, improper use, voltage,
abuse, or failure to follow instructions.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRAN TIES EXPRESSED
OR IMPLIED, AND OF ALL OTHER OBLIGATIONS OR LIABILITIES ON OUR
PART, INCLUDING THE IMPLIED WARRANTY OF MERCHANTIBILITY.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION
ON THE FACE HEREOF. We neither assume, nor authorize any other person
to assume for us, any other obligation or liability in connection with the sale of said
GOLD MEDAL equipment or any part thereof.

The term “Original Purchaser” as used in this warranty shall be deemed to mean that
person, firm, association, or corporation who was billed by the GOLD MEDAL
PRODUCTS COMPANY, or their authorized distributor for the equipment.

THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL
PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT 1-800­543-0862 TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE
EQUIPMENT PROBLEM, AND, IF NECESSARY, FOR INSTRUCTIONS
CONCERNING THE REPAIR OR REPLACEMENT OF PARTS.

GOLD MEDAL PRODUCTS COMPANY
10700 Medallion Drive
Cincinnati, Ohio 45241-4807 USA

www.gmpopcorn.com

Phone: [phone]
Fax: [phone]

© The text, descriptions, graphics and other material in this publication are the proprietary
and exclusive property of Gold Medal Products Company and shall not be used, copied,
reproduced, reprinted or published in any fashion, including website display, without its
express written consent.