Gold Medal 2004SL Installation Manual

AstroPop Warmer

a

Instruction Manual

Models #2004 and #2004SL

Part No. 40269

Revised August 2000

Cincinnati, OH 45241-4807 USA

e-mail: [e-mail] www.gmpopcorn.com

SAFETY PRECAUTIONS

a

Astro-Pop Warmer

a

INTRODUCTION

Your new #2004 Astro-Pop Warmer is shipped completely assembled, ready to operate. After remov­ing the corrugated carton from the machine, check thoroughly for any damage which may have
occurred in transit. Claims should be filed immediately with the transportation company.

Remove all cardboard packing and tape from the machine. Wipe all exposed surfaces with a damp
cloth to remove fingerprints, smears, etc. which may have occurred during unpacking and handling.

ELECTRICAL REQUIREMENTS

Standard voltage for the Astro-Pop Warmer is 120V, 60 cycle, single phase, A.C. current. The unit
should be placed on its own 20 Amp (4 wire) electrical circuit. The switches to control the heater and
lights are located at the top on the inside of the cabinet.

CARE AND CLEANING

The aluminum frame of the Warmer is easy to keep clean. Usually a damp cloth will remove all dirt
and grease spots. NEVER USE ABRASIVES on the aluminum framework. The glass should always
be clean and sparkling. Remember the inside of the glass must be cleaned too. The vertical air ducts,
mounted on the inside of the cabinet, disassemble without tools for easy cleaning. Periodically, empty
out all the popcorn and remove the shelves and clean the inside of the machine. A damp cloth will
usually pick up all the scraps of popcorn that has been spilled. Empty the old maid drawers and wipe
clean. Remove the bottom cabinet pans and clean out any stray debris.

1

MODEL #2004