Gold Medal 1888 Installation Manual
Sno-King
Instruction Manual
Model No. 1888, 1888EX
Part No.12666
Cincinnati, OH 45241-4807 USA
Sno-King Model No. 1888, 1888EX
SAFETY PRECAUTIONS
http://www.gmpopcorn.com Page 2
Sno-King Model No. 1888, 1888EX
INSTALLATION INSTRUCTIONS
Inspection Of Shipment
Unpack all cartons and check thoroughly for any damage that may have occurred during transit.
Damage claims should be filed immediately with the transportation company.
Setup
Your new Sno-King is completely assembled and tested at the factory. Remove all packing material and
tape before starting operation.
Electrical Requirements
The following power supply must be provided:
1888: 120VAC, 60Hz, 972W
1888EX: 230V, 50Hz, 972W
Your electrician must furnish sufficient power for proper machine operation. We recommend
this shaver be on a dedicated and protected circuit. Failure to wire properly will void the
warranty and may result in damage to the machine.
It is Gold Medal® Products Company’s recommendation that this machine be plugged directly
into a wall outlet. The use of extension cords is not recommended due to safety concerns, and
may cause sacrificed and/or reduced performance.
Before You Plug In the Machine
1. Make sure the wall outlet can accept the grounded plugs (where applicable) on the power
supply cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician
inspect the outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded receptacle adapter.
http://www.gmpopcorn.com Page 3
Sno-King Model No. 1888, 1888EX
GENERAL INSTRUCTIONS
To Operate the Sno-King
1. Load hopper with Ice.
2. Close pusher cap, and apply gentle downward pressure.
3. Turn on the power switch.
4. Press and hold in the momentary switch. Release the button once all of the ice has been shaved.
5. Do not lift the pusher cap until the motor is off and the shaver head has stopped.
NOTE: Never allow any foreign or metallic objects around the shaver area of the Sno-King. Ice
picks, scoops, and debris that may be in the ice often damage blades.
Ice Requirements
The Sno-King can take ice cubes or block ice, if you break the block into pieces approximately 2 to
3 inches in size.
NOTE: The ice will not enter the shaving chute if the pieces are too large
.
Daily: Cleaning the Ice Shaver
1. Wipe the outside parts with a clean cloth.
DO NOT use oven cleaners, as they will damage parts of the machine.
2. Ammonia cleaners will damage the Lexan Windows. Use only non-ammonia cleaners, such as
Gold Medal® Watchdog Glass Cleaner (item number 2588).
http://www.gmpopcorn.com Page 4
Loading...