Gold Light Toys Factory JG2017B24GT User Manual
2 PACK DRONES & FLAG DRONE RACER SET
12+
Getting to Know Your Drone
PLEASE READ ALL WARNINGS AND
INSTRUCTIONS PRIOR TO USE. KEEP THIS
DOCUMENT AS IT CONTAINS IMPORTANT
INFORMATION ABOUT YOUR DRONE.
1. PREPARE FOR FLIGHT
• Drone must be charged before each use
(Cable included)
• Indicator light will turn off once fully charged
• Install batteries in remote
2. PAIR YOUR DRONE
Before each flight pair the remote with the
drone:
1. Turn your drone on and place on a flat, level
surface
2. Turn on the remote on and move the left
joystick up, then down
3. The beep will indicate successful pairing
4. Repeat steps 1 and 2 if necessary
4. REMOTE CONTROL OVERVIEW
Practice flying your drone below 10 feet and at
low speeds until comfortable with all controls
to avoid unnecessary damage or injury
• Left joystick: left/right controls spin and
Up/Down controls elevation
• Right joystick: controls flight direction
• Direction Trim: use to eliminate drift
To cut power to drone, move left joystick to
down position
3. DIRECTIONAL LIGHTS
• White lights indicate the front of the drone
• Red lights indicate the back of the drone
• Not applicable in auto-orientation mode
QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WE’RE HERE TO HELP
CUSTOMER SERVICE
(800) 374-2744
Before calling please locate the 10-digit
code printed on the back of your remote
©2017 MerchSource, LLC. All rights reserved.
Distributed by MerchSource, LLC, Irvine, CA 92618.
For technical support, please visit www.merchsource.com or call
1-800-374-2744.
The artwork and design of this manual are protected by US copyright law
and may not be reproduced, distributed, displayed, published or used for
any purpose without prior written permission. It is not permitted to alter,
remove or reproduce any trademarks or copyright notice from this
manual.
ADULT ASSEMBLY, CHARGING, AND
BATTERY INSTALLATION IS REQUIRED.
ADULT SUPERVISION IS REQUIRED.
WARNING:
CHOKING HAZARD -
Not for Children under 3 years.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may
differ slightly from the actual product.
PATENT PENDING
Small Parts.
Printed in China.
2 PACK DRONES & FLAG DRONE RACER SET
INTRODUCTION
Congratulations on your purchase of the
Rechargeable 2.4 GHz 2 Pack Drones &
Flag Drone Racer Set. Get ready to soar
to new heights. Master the art of drone
flying with remote control
maneuverability. These lightweight
drones will provide hours of fun.
TABLE OF CONTENTS
SPECIFICATIONS
Drone Battery: 350 mAh Li-po
Remote Controller Battery: 6 x 1.5V “AA”
Charging Time: 100 minutes
Maximum Recommended Altitude: 150 ft.
General Warnings Page 1
Contents, Remote Battery Installation, Battery Warnings Page 2
Charging LiPo Battery and Replacing Propellers Page 3
Remote Overview Page 4
Operating Drone Page 5
Auto Orientation and Tips Page 6
Obstacle Course Setup Page 7
iPrinted in China.
2 PACK DRONES & FLAG DRONE RACER SET
READ ALL WARNINGS AND PRECAUTIONS BEFORE USE
SAFETY WARNINGS
• Not recommended for children under 12 years of age. As with all electrical products, precautions should be
observed during handling and use to reduce the risk of electrical shock.
• Adult supervision is required at all times
• Drive drone only on smooth flat surfaces
• Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected
crashes.
• Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of
others.
• The drone shall never be modified or used for anything except its intended purpose.
• Before each use, an adult should review the product and battery to determine that no damage or hazards exist
• DO NOT TOUCH SPINNING PROPELLERS
• Do not allow anything to intentionally make contact in any way with spinning propellers
o Prevent contact with spinning blades by turning off remote prior to handling drone
• Use caution and pay attention to your surroundings while operating drone
• Do not fly drone into animals, people, or inanimate objects
• Keep drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas.
• Do not operate in rain, heavy wind, and or any type of severe weather
• Do not land drone on wet surfaces
• Never touch or allow others to touch drone while it is flying
• Always turn drone off when it is not in use
• Always fly drone in large open areas
• The drone will lose controlling capabilities if fly distance is more than maximum recommended altitude of 100 ft.
Keep below 100 ft. to avoid potential crashing risk.
WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
Fly-aways are the responsibility of the individual
pilot and will not be replaced by the manufacturer.
Drone is powered by a rechargeable 3.7V 350mAh Li-Po battery (included). Transmitter
requires 6 “AA” batteries (not included). Colors and styles may vary. *This drone weighs
0.192 lbs (87g). As of December 21, 2015, the Federal Aviation Administration (FAA) only
requires registration on unmanned aircrafts weighing more than 0.55 lbs. Visit
www.faa.gov/uas/registration/ for more information. Although the FAA does not require this
drone to be registered, ongoing compliance with federal, state, and local laws is an owner’s
sole responsibility. Always fly safely and respect the privacy of others.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
TROUBLESHOOTING:
When remote switch is turned on, the remote light does not
illuminate:
1) Check that batteries in the remote are installed correctly OR
2) Replace with new batteries
When the remote is switched on, the remote LED is flashing and
remote is beeping:
1) Remote batteries are low; replace them with new batteries
Drone and remote properly pair, but the drone will not lift-off:
1) Drone Li-Po needs charging. Use charging cable to connect the
drone to power source.
After trimming the drone, the drone flight is very unstable and
cannot fly properly:
1) One or more blades are most likely damaged;
2) Turn off the drone and remote.
3) Replace with the proper number replacement blade and try
flying again.
After impact, the drone is unstable:
1) Put the left remote control lever to the left bottom and put the
right remote control lever to the right bottom at the same time
which connected to the drone (diagram to right).
2) If the above does not resolve the issue, reboot the drone and
controller and pair again.
Remote Controller and Drone can not be paired:
1) Check Point: Remote Controller must be closed to Drone, not
exceed 4 meters.
Note: If there are 2 sets of Drones within 4 meters for Pairing, you
must pair one successfully before pairing the second set.
1Printed in China.
Loading...