Golden Technologies Power Lift User Manual

Power Lift & Recline Chair
OWNER’S MANUAL
MAXICOMFORT™ MODELS
401 Bridge Street Old Forge, PA 18518
YOUR LIFE IN MOTION
www.goldentech.com
Dear Valued Customer,
Thank you for purchasing this Golden Technologies Power Lift and Recline Chair. Your Golden chair is tested and certifi ed by NRTL Met Labs to UL and CSA electrical standards to assure that you
have purchased one of the safest chairs available. We believe that this product is made from the highest quality components available, is engineered to give you maximum service with minimum maintenance, and is backed up by the strongest warranty in the industry. We hope that you enjoy years of pleasurable use of your Golden Technologies chair and that this chair becomes a true assist to you in both sitting down and standing up.
Please take a few moments to review this manual to become familiar with the operation of this chair and our warranty. If you need additional information, please call the dealer from whom you purchased this chair.
Also, please note the following safety information: This power lift and recline chair is a medical device designed to help you sit down and stand up. Do not allow children to operate the chair at any time. When not in use, the chair should be kept in the sitting position.
Again, thank you for selecting this Golden chair.
Sincerely,
Robert Golden
Chairman and Founder
Complies with UL 73
and CSA C22.2 No. 68
Listing # E112417
2
IMPORTANT!
READ THIS MANUAL FIRST BEFORE INSTALLING OR OPERATING YOUR POWER LIFT AND RECLINE CHAIR.
Your power lift and recline chair has been engineered from the leg levelers up
to provide the ultimate in strength and reliability.
Great care has been taken to provide you with total comfort and safety. Golden
Technologies thoroughly inspects and tests each unit prior to shipment.
Your Golden power lift chair is a medical device. Therefore, you are required to exercise caution when operating it to ensure your personal safety and that of others around you. The following are rules for the safe operation of your Golden power lift chair.
WARNING
Care should be taken in the unpacking of this unit, so as not to cause injury to
persons or damage to the unit. Dispose of all plastic bags and covers, as they
can be a smothering hazard to small children.
Do not allow children or pets near the chair while the chair is operating.
Do not allow children to play with or operate the chair at any time.
Hand control should be unplugged and placed out of reach of children when
the chair is not in use.
Do not fl op down into the chair when getting into it, or while it is in its lift
position. Flopping down into the chair will damage it and could cause personal
injury.
Do not allow anyone to sit on your lap, or on the arm of the chair, or on the
footrest while operating the chair, as it may cause tipping and could result in
personal injury.
Do not place fi ngers or hands between the seat cushion and the inside arm of
the chair while sitting in the chair or when the chair is in operation or plugged
into a power source.
Do not retrieve fallen objects from inside or under the chair while the chair is
plugged into a power source.
Do not operate chair if there are any persons, pets or other obstructions under
or in front of the footrest, under the chair or behind the chair.
Do not smoke while operating, sitting or resting in the chair.
To reduce risk of electrical shock, do not immerse any of the electrical
components into a liquid, or spill any liquids onto electrical components. Do
not open any of the electrical components. There are no serviceable parts.
Warranty will be void if any of the electrical components are opened by other
than a qualifi ed service person.
Make sure the chair is placed at the specifi ed distance from a wall/corner
(page 4). Failure to do so can damage the chair and will void the warranty.
Do not use any type of electrical extension cord to plug your chair into an
electrical outlet.
3
INSTALLATION MAXICOMFORT MODELS
1. Remove the transformer from the transformer box (located behind the lower outside
back) and install two 9 volt alkaline batteries into the sockets on the transformer.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Power cable is located under the chair attached to the motor shaft with white zip tie. Remove zip tie, extend cable under and out behind the chair.
T
N
E
E
D
T
A
P
L.E.D. light
From motor
Bottom view of
Transformer
Install two 9 volt batteries in transformer for battery backup (See page 7) (batteries not included)
Plug
To outlet 115-120V A.C.
L.E.D. light
DC Power
Transformer
3. Place the chair in the desired
25"
25" 25"
Corner
position in the room, keeping it 25" away from the wall. If placing the chair into a corner, keep it 25" from the wall as shown. See distance chart below for your model.
Distance Required From Wall When Reclined
Model Number Wall Corner Model Number Wall Corner PR-756MC 25 in. 25 in.
PR-756L 27 in. 27 in. PR-505JP 22 in. 22 in. PR-505SM 23 in. 23 in.
Wall
Side
View
To p
View
PR-505M 24 in. 24 in. PR-505L 27 in. 27 in. PR-506 27 in. 27 in. PR-510 27 in. 27 in.
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against it. Raise the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the magazine pocket on the arm of the chair.
AUTO DRIVE HAND CONTROL OPERATION
1. To recline the back of the chair, press button (S1) and hold until the back
reaches the desired position. Then release the button.
2. To bring the back of the chair to an upright position, press button (S2) and hold until the back reaches the desired position. Then release the button.
4
Loading...
+ 8 hidden pages