0
i
d
-
c
P
o
G
a
S
H
c
r
m
U
M
gh
1
n
s
a
Ele
troni
ro
c Ball
S-S
du
st fo
odiu
W1
t
Hi
2A00
a
-pres
u
ure
l
Tel：
E-ma
Web：
10-52985603
l：Jason@gol
www.golden
en-scorpion.c
scorpion.com
m
1 Features & Benefits：
Suitable Lamp：
1000W HPS of PHILIPS Master Greenpower TD 1000W EL Plus double end lamp
GE Lucalox LU400V/1000W/TD/PSL E40/E39
Gavita Pro 1000W EL DE double end lamp
Electronic ballast for single lamp, suitable for horticulture/ indoor/greenhou se use.
Lower input wattage and energy saving compared with magnetic system
Long lamp life by constant output power
High frequency lamp operation, preventing acoustic resonance in the lamp arc tube
Various protection functions: output short circuit protection, output open circuit
protection, lamp ignition failure protection, etc.
Ballast life reaches to 10，000 hours with top case temperature less than 70℃
Light weight and no noise
Easy to install and convenient for use
Green , reduce the pollution to the power net
Tel：010-52985603
E-mail：Jason@golden-scorpion.com
Web：www.golden-scorpion.com
2 Electronic Parameter:
Model Name GS-SHW1U2A001
Input voltage
Input wattage
Input current
Energy loss 50~100W
PF >0.98
THD <10%
CF <1.7
Environmental temperature
Top case temperature
240Vac±10%，60Hz
1000W±5%@240V
＜4.7A@240V
-10℃~+40℃
70℃
Product Parameter
3
Length：9.80" [250mm]
Width： 6.22" [158mm]
Height： 3.85" [98mm]
Case： Metal
Tel：010-52985603
E-mail：Jason@golden-scorpion.com
Web：www.golden-scorpion.com
4 Wiring Diagram
5
Installation Notes
Make sure the correct connection of input and output wires of electronic balla st
Place the ballast in safe and reasonable position, especially paying attention to
waterproof
Connect output wires of ballast with metal halide lamp in a solider and safe way
Match ballast with compatible lamp（1000W HPS）
Do not have live-line working when connecting input wires
Power ballast in AC240V after everything is readily connected
Tel：010-52985603
E-mail：Jason@golden-scorpion.com
Web：www.golden-scorpion.com
6 Cautions:
Please use this product under the regulated power and environment temperature.
Must consider heat elimination of electronic ballast when selecting lamp, ensurin g top
case temperature no more than 70℃.
Case of electronic ballast must be grounded in proper way.
NOTE:
This device complies with Part 18 of the FCC Rules.
Changes or modifications not expressly approved by the party res ponsible for
compliance could void the user's authority to operate the equipment.
This product may cause interference to radio equipment and should not be
installed near maritime safety communications equipment or other critical
navigation or communication equipment operating between 0.45–30 MHz. If this
occurs, please change outlet or move the lamp far away from other appliance.
(a) The interference potential of device or system:
“Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accep t any interference
received, including interference that may cause undesired operation.”
(b) Simple measures that can be taken by the user to correct interference:
“NOTE: This equipment generates, uses and can radiate radio freque ncy energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.”
Tel：010-52985603
E-mail：Jason@golden-scorpion.com
Web：www.golden-scorpion.com
Loading...