Golden Rock Technology WCSWD001 User Manual

EXOvault wireless charging stand instructions

Plug into USB power adaptor.
When charger is plugged in it

is ready to accept phone. The
charger will be in sleep mode
using minimal power until it
detects a phone has been
placed on charger.

Place Qi compatible
phone on stand in
vertical position to charge

Phone will indicate the charging has begun. Phone will indicate
when the phone is fully charged. Charger will automaticly stop
charging when phone signals that the phone is full. Charger only
works with Qi compatible phones. Non Qi phones will not
charge on this stand.

Instructions Page 1

Place Qi compatible phone
on stand in horizonal position
to charge

FCC Warning Statement:

Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
.. Reorient or relocate the receiving antenna.
.. Increase the separation between the equipment and receiver.
.. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
.. Consult the dealer or an experienced radio/TV technician for help.

Instructions Page 2