Golden Prosper BNTXCP2 User Manual

Wireless Door Chime
Accessory Transmitter

This Package includes:

• Door chime button

• Battery

You will need a screwdriver and other tools depending on
how the button is mounted.

Product Features include:

• Battery powered transmitter - No wires to run.

• Channels are selectable to allow more then one door

chime to ring at the same time.

To get the most out of this product, please read
these instructions carefully.

INSTALLATION

1. Install battery.

Remove the cover from the side of the chime button case.
Lift the case up and away from the back. Install battery
(supplied).

2. Set the frequency code to match your door chime.

Make sure that the frequency set matched on both the
button and chime. Replace cover removed in Step 1.

3. Before mounting, test the range.

Put the chime and the button where you want to mount
them and then press the button.

4. Mount chime button.

Drill 3/4” diameter x 3-1/2” deep hole at chime button
location. Insert button into escutcheon and use provided
hardware to install.

OPERATION

Press the door chime button to verify that the button and
chime work properly. When the button is pressed, the chime
should sound. If it doesn’t, check that the frequency codes
are set the same and that the alkaline batteries are fresh.

BATTERY REPLACEMENT

Chime

Replace batteries following door chime instructions.

ADDITIONAL DOOR CHIMES

When installing other Wireless Door Chime sets, remenber

to set switches to different settings to avoid interference. If
you want them to all ring at the same time, set them to the
same frequency code.

TROUBLESHOOTING

The range of the door chime depends on location,
temperature and battery condition. If you are having
problems with this product, please try the solutions listed
below.

Chime rings on its own:

• A neighbor may have a wireless chime set with the same

frequency jumper settings. Change the chime and button
frequency jumpers.

Chime doesn’t sound:

• Make sure the button and the chime jumpers are set the

same.

• Replace the button battery. Also check chime batteries.

Batteries are OK, but chime does not work when
installed:

• Mounting the chime or button directly on metal, concrete

or near metal studs reduces the range.

• Do not mount the chime too close to ground level

concrete slabs which may also reduce the range. Mount
the chime away from the floor.

• Try different locations for the chime closer to the button.
Also, try to orient the chime at a different angle to increase

the range. Range is most effective to the sides of the

button.

The user is cautioned that changes or modifications
not expressly approved by the party responsible for

regulatory compliance could void the user’s authority to

Questions on this product?

Call 1-800-637-1453

7:30 AM to 6:00 PM Central Time, Weekdays

Regulatory Information

operate this equipment.

Button

Open button case (see Step 1). Replace battery with one

N Cell, 1.5V alkaline battery. Close button case.

FCC NOTE

• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation.

• This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.

• If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

WARRANTY

BROAN-NUTONE ONE YEAR LIMITED WARRANTY

Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in
materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.

During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which
is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND
INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR
DUCTING. This warranty does not cover (a) no
been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan-NuTone), faulty
installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the one-year period as specified for the express warranty. Some states
do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OPTION, SHALL BE THE
PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE
LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH
PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This
warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number below, (b) give
the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of
requesting warranty service, you must present evidence of the original purchase date.

Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027 www.nutone.com 800-558-1711

rmal maintenance and service or (b) any products or parts which have

99528379A