Golden Lighting 9903-6 MG User Manual
For Customer Service, contact the place of purchase to arrange for replacement parts.
INSTALLATION INSTRUCTIONS
Fixture Name: AUTUMN TWILIGHT 9903-6 MG
For Chandelier Light Fixture
HANGING THE FIXTURE（Fig.1）
FIXTURE WIRES
(or Green)
HOUSE WIRES
(Neutral)
GREEN
(Ground)
JUNCTION BOX
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
1. Carefully remove the new fixture from the carton and
the yellow bag that holds a l l parts. Check that all parts
are included as shown in th e illu st ration and parts list.
2. Shut off the power at the circuit breaker and remo ve
old fixture from ceiling, including the old mounting
strap.
3. The Mounting Strap (B) contains several pairs of
threaded holes, find th e pair of holes that match the
holes spacing in your fixture Canopy (D) and thread
the Nipple (A) half way into the Fixture Mounting Strap
(B).
4. Attach the Fixture Mounting Strap (B) to the Junction
Box using the two Mounting Screws (C). Tighten the
Screws (C) securely with screwdriver.
5. Adjust correct length of cable needed for hanging
height. You may need to cut short th e w ir e and
reconnect with transformer refer original mode.
CONNECTING THE WIRES (Fig.2)
6. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) an d
WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire (GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green
Ground Screw on the Mounting Bracket (B) or connect
both wires together using the correct size of wire
connectors.
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction
Box.
FINISHING THE INSTALLATION (Fig.3)
9. Raise Canopy (D) to the ceiling and secure in place
by tightening the Deco Nut (F).
10. Install the light bulbs and crystals as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW CO M PLETE. TURN POWER ON
AT TO THE JUNCTION B O X & TES T THE FIXTURE.
Fig.1
(CEILING)
Fig.2
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
A
B
C
D
F
BLACK
(Hot)
WHITE
CSA055306HALG1.DOC
For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & A SSEMBLY S HEET
Fixture Name: AUTUMN TWILIGHT 9903-6 MG
Notice:
Halogen,
9903-6 MG
A
24 PCS48 PCS27 PCS9 PCS
This fixture assembled PO: Date:
Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
Company Name:______________________Co Account#:__________
PARTS LIST
below to be filled out by retailer
Canopy
1ea Φ175*H65 ㎜
Mounting Screws
2ea G8/32*H32 ㎜
Green Screw
1ea G8/32*H8 ㎜
Crystal Leaf
PT-CRYSTAL-9903 LEAF
51ea W27*H65 ㎜
Hex Nut
1ea NPS-1/4-18
Nipple
1ea NPS 1/4-18*85
Mounting Strap
1ea W103*T2.0 ㎜
㎜
Wire Connectors
3ea Orange
Deco Nut
1ea Φ19 ㎜
Bulbs
6ea
Type G4 20W
Part Needed ______________________________ Quantity _________________________________
Part Needed ______________________________ Quantity _________________________________
Reason why (missing, scratched, broken glass, bent, bad finish)
Comments __________________________________________________________________________
FIXTURE ASSEMBL Y INSTRUCTIONS
Read and review installation instruction sheet
before assembling the fixture
1. Open bag on the arm and carefully arrange the
bead strings.
2. Screw Crystal Leaf (A) on the arm.
Hold carefully by the metal base to prevent the
crystal from cracking.
3. Install the light bulbs in accordance with the
fixture's s p ecification.
Bulb note: Use a tissue or paper towel to hold the
bulb and push down into soc k et. Oils or dir t can
cause the bulb life t o s horten. Rubbing alcohol is
recommended to clean the bulbs if dirty.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
Fig.3
CSA055306HALG2.DOC
Loading...