Golden Lighting 9363-9 GMT-OP User Manual
2ea 5/32-IP*H3mm
(PT-OSRING 9363)
1ea ∮124*H8mm
1ea ∮145*H8mm
1ea
∮130Dia*H63.5mm
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS & ASSEMBLY SHEET
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
FIXTURE WIRES
HOUSE WIRES
I
Fixture Name: Presilla 9363-9 GMT
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Mounting Strap Mounting screw Mounting screw
1ea L104*W24*H11mm 2ea 8/32-IP*H1" 2ea 5/32-IP*H1-1/2"
Hex nut Wire connnector Finial
3 ea A3 Orange 2ea 3/8-IP*H9mm
Metal ring
U Iron Clip
9ea L101*W70*H68mm
Canopy
Rod Rod
3ea 12.7mmDia* H12“ 1ea 12.7mmDia* H6”
Part Needed Quantity
Part Needed Quantity
IXTURE ASSEMBLY INSTRUCTIONS
F
Read and review installation instruction sheet, but do not
install before assembling the fixture.
9363-9 GMT
G
1. By measuring determine correct number of rods needed for
proper hanging height.
* This fixture includes 4 rods (6", 12", 12", 12")
F
H
These three Rods
may be removed
additional Rods (ROD-
12 GMT)
2. To shorten the fixture; slide the excess rods off the wires.
may be added.
To lengthen add additional rods.
or
NOTE: INSTALL THE GLASS ASSEMBLY AFTER
THE FIXTURE IS HUNG.
For Customer Service, contact the place of purchase to arrange for replacement parts.
9363 PartsInstallation_20111212m.xls
J
PARTS & ASSEMBLY SHEET continued
J
Fixture Name: Presilla 9363-9 GMT
3. Pull the fixture’s wire through the Rods.
4. Thread Rod (J) into Frame (K) until tight.
5. Thread Rod (I) into Rod (J) until tight. repeat for
any additional rods.
6. Feed the fixture wires through the Canopy (G) and
pull the wires until taut.
7. Thread Canopy (G) into Rod (H) until tight.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
8. Place the U Iron Clip (N)"OSRING" over the Socket
(O).
9. Slide the Glass Shade (L) over Socket (O) and
secure it by threading the White Ring(M-1) and
Socket Ring (M) onto the Threaded Socket (O) until
tight.
10. Place the Metal rings (Q) onto the small nipple (P)
on the inner side of the fixture frame. The fixture
arms can be adjusted to their correct positions to
meet these points.
11. Install the light bulbs in accordance with the
fixture's specification.
(DO NOT EXCEED MAXIMUM WATTAGE RATING!)
P
K
G
F
H
I
M
M-1
L
N
O
Q
For Customer Service, contact the place of purchase to arrange for replacement parts.
9363 PartsInstallation_20111212m.xls
Loading...