Golden Lighting 9106-M3 PW-OPL User Manual
2ea 5/32-IP*H3mm
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
NOTE: I
PARTS & ASSEMBLY SHEET
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
I
Fixture Name: Taylor 9106-M3 PW
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Mounting Strap Mounting screw Mounting screw
1ea L104*W24*H11mm 2ea 8/32-IP*H1" 2ea 5/32-IP*H1"
Hex nut Wire connnector Finial
3 ea A3 Orange 2ea 3/8-IP*H9mm
Canopy Rod Rod
1ea ∮127Dia*H20mm 3ea 12.7mmDia* H12“ 1ea 12.7mmDia* H6”
Part Needed Quantity
Part Needed Quantity
IXTURE ASSEMBLY INSTRUCTIONS
F
Read and review installation instruction sheet, but do not
install before assembling the fixture.
1. By measuring determine correct number of rods needed for
proper hanging height.
* This fixture includes 4 rods (6", 12", 12", 12")
2. To shorten the fixture; slide the excess rods off the wires.
To lengthen add additional rods.
9106-M3 GMT
G
F
H
J
These three Rods
may be removed
additional Rods
may be added.
or
NSTALL THE GLASS ASSEMBLY AFTER
THE FIXTURE IS HUNG.
For Customer Service, contact the place of purchase to arrange for replacement parts.
9106 PartsInstallation-121208.xls
PARTS & ASSEMBLY SHEET continued
J
N
Fixture Name: Taylor 9106-M3 PW
3. Pull the fixture’s wire through the Rods.
4. Thread Rod (J) into Frame (K) until tight.
5. Thread Rod (I) into Rod (J) until tight. repeat for
any additional rods.
6. Feed the fixture wires through the Canopy (G) and
pull the wires until taut.
7. Thread Canopy (G) into Rod (H) until tight.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
8. Slide the Metal candle sleeve (L) over Socket (M)
and put the Shade (N) on the sleeve.
*Shade will be secured by the light bulb.
9. After installing all the components adjust the
fixture's arms spacing for even balance.
9. Install the light bulbs in accordance with the
fixture's specification.
(DO NOT EXCEED MAXIMUM WATTAGE RATING!)
G
F
H
I
K
L
M
For Customer Service, contact the place of purchase to arrange for replacement parts.
9106 PartsInstallation-121208.xls
Loading...