Golden Lighting 8118-M1L PW User Manual
NOTE: I
Read and review installation instruction sheet
PARTS & ASSEMBLY SHEET
Notice:
Fixture Name: Alston Place 8118-M1L PW
This fixture assembled PO:__________ Date: ________
Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement
parts.
PARTS LIST
Canopy Mounting Screws Top loop
1ea ∅6"*H1-3/4"
1ea 1ft 3.8mm 3ea P3 Orange 1ea 1/4-IP*H75mm
Chain connector
2ea 5.8*H61mm 1ea 1-1/4"*H42mm 1ea W4-1/8"*E1"*H5mm
12" Rod
3ea 1/8-IP*H305mm
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
2ea 8#32-IP*1" 1ea 1/8-IP*H60mm
Wire connectors NippleChain
Canopy loop
with Collar
Mounting strap
FIXTURE ASSEMBLY INSTRUCTIONS
before assembling the fixture.
ASSEMBLING THE FIXTURE (Fig.1)
1. By measuring determine correct number of
rods and chain needed for proper hanging height.
There is 1foot of chain and 2 optional 12" rods
included.
2. To shorten the fixture slide the excess 12" rods
off the wire.
3. To lengthen the fixture thread the additional
rods onto the wire or substitute longer chain for
the 1 foot length included.
NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
8118-M1L PW
Fig 1
These two Rods may
be removed
or
additional Rods may be
added.*
additional chain may be
added.*
*available for purchase
separately
For Customer Service, contact the place of purchase to arrange for replacement parts.
12. Install the light bulb in accordance with the fixture's
PARTS & ASSEMBLY SHEET
Fig 2
Fixture Name: Alston Place 8118-M1L PW
ASSEMBLING THE FIXTURE (Fig.2)
4. Pull the fixture’s wire through the Rods until taut.
5. Thread Rod (U) into Frame (P)until tight.
6. Thread Rod (M) into Rod (U) until tight. repeat for
any additional rods.
7. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (C2) then remove the
excess Chain (C2) and discard it.
8. Use one chain connector (E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
9. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
10. Slip Canopy loop collar (B2) over the chain, then
do the same with the canopy (F2).
11. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (A2) and close the chain
connector.
12. Make sure the weight of the fixture will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
13. Place the Glass Shade (O) over the Threaded
socket (P),secure the Glass Shade (O) by threading
by the Socket Ring (N) until tight.
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
For Customer Service, contact the place of purchase to arrange for replacement parts.
Loading...