Golden Lighting 8063-BA4 BUS User Manual

PARTS & ASSEMBLY SHEET

_

Fixture Name: Heartwood 8063-BA4 BUS

This fixture assembled PO:__________ Date: ________

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any

parts are missing or damaged, please note onthis sheet and contact the place of purchase to
arrange for replacement parts.

PARTS LIST

Mounting
Strap

Hex nut 2ea

Part Needed Quantity
Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments

1ea

Company Name:_______________________Co. Account #:________
to be filled out by retailer

Mounting
Screws

Wire
connectors

4ea Deco Nut 2ea

2ea

Socket
Washer

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet
before assembling the fixture.

Fig 1

8063-BA4 BUS

4ea

1.Slide the Glass Shade (R) and Socket
Washer (S) over Socket( Q) and secure Glass
Shade (R) by threading the Socket Ring(T) to
Socket (Q) until tight.

2. Install the light bulb in accordance with the
fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING!)

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

For Customer Service, contact the place of purchase to arrange for replacement parts.

INSTALLATION INSTRUCTIONS

Fixture Name: Heartwood 8063-BA4 BUS

For Wall Mount Light Fixture

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.

HANGING THE FIXTURE (Fig.1)

1. Carefully remove the new fixture from the carton
and the yellow bag that holes all your parts. Check that
all parts are included as shown in the illustration and
parts list.

2. Shut off power at the circuit breaker and remove the
old fixture from wall, including the old mounting strap.

3. The Mounting Strap(F) contains several pairs of
threaded holes, find the pair of holes that match the
holes spacing in your fixture Back Plate(H) and thread
the two Mounting Screws(D) half way into the
Mounting Strap(F) and secure with Hex Nut (G).

4. Place the Mounting Strap(F)over the Junction Box
(A)so the Mounting Screws(D) are vertical or
horizontal, as required by fixture type.

5. Attach the Mounting Strap(F) to the Junction Box
using the two mounting screws(H)and tighten securely
with screw driver.

CONNECTING THE WIRES (Fig 2)

6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).

7. Attach the GROUND wire(GREEN or COPPER)
from the Junction Box and the fixture Ground wire to
the green Ground Screw (I) on the Mounting Bracket
(F) or connect both wires together using the correct
size of wire connectors. -
NOTE:Twist the wires together in the same direction
you twist the wire connector (L) onto the wires.

8. Tuck these wire connections neatly into the Junction
Box.

Fig. 1

Fig. 2

FINISHING THE INSTALLATION (Fig.3)

9. After tucking these wire connections neatly into the
Junction Box and place the fixture Back Plate(P) over
the two Mounting Screws(D) and secure the Back
Plate(P) against the wall by threading two Deco
Nuts(O) over the two Mounting Screws(D) until tight as
shown on Fig.1.

10. Install the light bulbs and glass shade as per the
fixture assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.

Fig. 3

For Customer Service, contact the place of purchase to arrange for replacement parts.