Golden Lighting 8063-3P BUS User Manual

INSTALLATION INSTRUCTION CH-1

For Chain Hung Light Fixtures (Rev.

For Chain Hung Light Fixtures (Rev.07

For Chain Hung Light Fixtures (Rev.For Chain Hung Light Fixtures (Rev.

WAR NI NG ! SHU T P OW ER OF F AT F USE OR CIRC UI T B RE AK ER

HANGING THE FIXTURE

1. Shut off the power at the circuit breaker and remove old
fixture from ceiling, including the old crossbar.

2. Carefully unpack new fixture and lay all the parts on a clear
surface.

3. Thread nipple (C) into loop (F) until snug.

4. Thread other end of nipple (C) with loop attached into cross­bar (D) until snug.

5. Place lock washer (B) over of nipple protruding through
crossbar and thread hex nuts (A) onto nipple until tight.

6. Take this crossbar assembly and mount to ceiling junction
box with junction box screws (E) .Tighten screw securely
with screwdriver.

7. Use a pair of pliers to open one end link of the chain
provided, and connect to the fixture loop (J). Close the link.

8. By measuring, determine correct number of links needed for
proper hanging height. Using pliers disconnect and discard
remaining chain.

9. Lace the fixture wires through the chain.

10. Slip loop collar (H) over the chain, then do the same with the
canopy (G).

11. Open the other end link of the chain and hang the fixture on
the loop at the ceiling. Close the link.

12. Feed the fixture wires through the loop (F), and nipple (C)
and pull until taut.

CONNECTING THE WIRES (Fig.2)

13. Take the black wire from the ceiling junction box and the
smooth wire leg from the fixture and twist bare ends
together.

Twist wire connector onto end of wires until snug.

14. Repeat same process with white junction box wire and
ribbed wire of fixture.

NOTE: Twist wires together in the same direction you twist
the wire connector onto wires.

15. If your junction box has a grounding wire (green or bare
copper), attach this wire and the bare copper wire from the
fixture together as in step 13. If junction box has no ground
wire, attach the bare copper fixture wire to the junction box
with a screw.

16. Tuck these wire connections neatly into the ceiling outlet
box and then raise the canopy (G) all the way to the ceiling.

Raise the loop collar (H) and thread onto ceiling loop
protruding through canopy.

17. Install the light bulbs in accordance with the fixtures
specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
Turn power on at the junction box & test the fixture.
Your installation is now complete

（（（（

Fig.1

））））

07----02

02----07

0707

0202

07))))

0707

JUNCTION BOX
(CEILING)

J

A

B

D

C

E
F

G

H

CHAIN

2